Abstract:The micro-electro-mechanical system (MEMS) resonator developed based on surface processing technology usually changes the section shape either due to excessive etching or insufficient etching. In this paper, a section parameter is proposed to describe the microbeam changes in the upper and lower sections. The effect of section change on the mechanical properties is studied analytically and verified through numerical and finite element solutions. A doubly-clamped microbeam-based resonator, which is actuated by an electrode on one side, is investigated. The higher-order model is derived without neglecting the effects of neutral plane stretching and electrostatic nonlinearity. Further, the Galerkin method and Newton⁻Cotes method are used to reduce the complexity and order of the derived model. First of all, the influence of microbeam shape and gap variation on the static pull-in are studied. Then, the dynamic analysis of the system is investigated. The method of multiple scales (MMS) is applied to determine the response of the system for small amplitude vibrations. The relationship between the microbeam shape and the frequency response is discussed. Results show that the change of section and gap distance can make the vibration soften, harden, and so on. Furthermore, when the amplitude of vibration is large, the frequency response softening effect is weakened by the MMS. If the nonlinearity shows hardening-type behavior at the beginning, with the increase of the amplitude, the frequency response will shift from hardening to softening behavior. The large amplitude in-well motions are studied to investigate the transitions between hardening and softening behaviors. Finally, the finite element analysis using COMSOL software (COMSOL Inc., Stockholm, Sweden) is carried out to verify the theoretical results, and the two results are very close to each other in the stable region.

A system level modeling method for a MEMS variable cross-section beam driven by electrostatic force

Analytical model of electrostatic fixed-fixed microbeam for pull-in voltage

Modeling and Analysis for Moving Plate with Two-Dimensional Effect

Modeling and analysis for moving plate with two-dimension effect

Macromodeling Of The Electrostatically Actuated Rectangle Plate Based On Modal Projection

A Variational Beam Model for MEMS Driven by Electrostatic and Piezoelectric Forces

Research on Two-Dimensional Effect of Variable Cross-Sections Fixed-Fixed MEMS Beam

System-Level Modeling Method of Variable Cross-Section Beams

Dynamic Flexoelectric Actuation and Vibration Control of Beams

Modeling the Pull‐in Behavior of Electrostatically Actuated Micro Beams by an Approximate Finite Element Method

Analysis and Computation of a Deformation of a Microbeam Driven by Electrostatic Force

System-level dynamic simulation for a MEMS clamped-beam based on the mechanical description

Electromechanical coupling analysis for MEMS featured by stepped-height structure and concentrated load

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Numerical Simulation And Analysis Of An Electroactuated Mems Capacitive Switch Using Finite Element Method

An Improved Method for Electromagnetic Calculations of Dynamically Varying Cantilever Beam RF-MEMS Switches

Numerical Simulation and Analysis of Electrically Actuated Microbeam-Based MEMS Capacitive Switch

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error

Finite Element Solutions of Cantilever and Fixed Actuator Beams Using Augmented Lagrangian Methods

Dynamic Characteristics of Electrostatically Actuated Shape Optimized Variable Geometry Microbeam

Numerical simulation and analysis of an electroactuated beam using a radial basis function