An Assessment Method of High Temperature Creep Life of Steam Turbine Diaphragm

Liu-xin HU,Jian-hua XIN,Song GE,Ming-jun LIU,Yi-zhe ZHOU

DOI: https://doi.org/10.3321/j.issn:1000-6761.2009.03.006

2009-01-01

Abstract:Aiming at the difficult to assess high temperature creep in the imported unit properly, a method was put forward, which is to get material creep parameters by history deformation data of the diaphragm recorded in all previous overhaul, combined with the finite element analysis. By the method, the creep deformation under high temperature conditions was analyzed for Tll diaphragm of the 600 MW turbine, the prediction and assess for the deformation and stress of the diaphragm in posterior operation were done by commercial software. Results show that the highest stress of the diaphragm appeared at the blade's exit side of the shroud, at the blade root and trailing edge near the adge of horizontal split with its value of 160 MPa. If the unit runs 8000 hours every year, the hours that the diaphragm may be continuously used in service is about 30 years. It is same to the manufacturer's design data. So the diaphragm may not be replaced during a period of overhaul, and the maintenance costs are saved. It offers a practical method to assess the creep life of high temperature part of steam turbine and gas turbine.