Abstract:Friction compensation is particularly important for motion trajectory tracking control of pneumatic cylinders at low speed movement. However, most of the existing model-based friction compensation schemes use simple classical models, which are not enough to address applications with high-accuracy position requirements. Furthermore, the friction force in the cylinder is time-varying, and there exist rather severe unmodelled dynamics and unknown disturbances in the pneumatic system. To deal with these problems effectively, an adaptive robust controller with LuGre model-based dynamic friction compensation is constructed. The proposed controller employs on-line recursive least squares estimation (RLSE) to reduce the extent of parametric uncertainties, and utilizes the sliding mode control method to attenuate the effects of parameter estimation errors, unmodelled dynamics and disturbances. In addition, in order to realize LuGre model-based friction compensation, the modified dual-observer structure for estimating immeasurable friction internal state is developed. Therefore, a prescribed motion tracking transient performance and final tracking accuracy can be guaranteed. Since the system model uncertainties are unmatched, the recursive backstepping design technology is applied. In order to solve the conflicts between the sliding mode control design and the adaptive control design, the projection mapping is used to condition the RLSE algorithm so that the parameter estimates are kept within a known bounded convex set. Finally, the proposed controller is tested for tracking sinusoidal trajectories and smooth square trajectory under different loads and sudden disturbance. The testing results demonstrate that the achievable performance of the proposed controller is excellent and is much better than most other studies in literature. Especially when a 0.5 Hz sinusoidal trajectory is tracked, the maximum tracking error is 0.96 mm and the average tracking error is 0.45 mm. This paper constructs an adaptive robust controller which can compensate the friction force in the cylinder.

Compensator of the Disturbance Force for the Trajectory Tracking of Hydraulic 6-DOF Parallel Platform

Disturbance Observer-Based Nonlinear Motion Control of the Parallel Platform for Wave Compensation

Synchronous Tracking Control for Hydraulic Stewart Platform Based on Combination Tracking Errors in Operation Workspace

Decoupled Adaptive Terminal Sliding Mode Control Strategy for a 6-DOF Electro-Hydraulic Suspension Test Rig with RBF Coupling Force Compensator

Trajectory Tracking Control of a 6-DOF Hydraulic Parallel Robot Manipulator with Uncertain Load Disturbances

State Constrained Variable Structure Control for Active Heave Compensators.

Adaptive Robust Posture Control of A 3-Rps Pneumatic Parallel Platform with Unknown Deadzone

Model-based Trajectory Tracking Control for an Electrohydraulic Lifting System with Valve Compensation Strategy

High-performance Motion Control of the Hydraulic Press Based on an Extended Fuzzy Disturbance Observer

A Pressure-Displacement Control for an Active-Passive Hybrid Compensation System

Cross-coupling Integral Adaptive Robust Posture Control of a Pneumatic Parallel Platform

Trajectory Tracking Control of A Hydraulic Parallel Robot Manipulator with Lumped Disturbance Observer

Advanced Motion Control of Hydraulic Manipulator with Precise Compensation of Dynamic Friction

Disturbance Observer Based Position Tracking of Electro-Hydraulic Actuator

Adaptive Robust Motion Trajectory Tracking Control of Pneumatic Cylinders with LuGre Model-Based Friction Compensation

Nonlinear adaptive position tracking of an electro-hydraulic actuator

Adaptive sliding-mode trajectory-tracking control of hydraulic Stewart platform

Adaptive Robust Trajectory Tracking Control of a Parallel Manipulator Driven by Pneumatic Cylinders

Nonlinear Control for an Active-passive Hybrid Compensation System

Decoupling Compensation for Damping Improvement of the Electrohydraulic Control System with Multiple Actuators

Motion Control of a Hydraulic Manipulator with Adaptive Nonlinear Model Compensation and Comparative Experiments