Abstract:There are three difficulties in the topology optimization problem of continuum structure:1) The problem under multiple load case is not easy to be approached than that under single load case, because the former becomes a multiple objective problem on the basis of compliance objective function. 2) The problem with local constraints, such as elemental stress limit, is not easy to be solved than that with global constraints, such as displacement or frequency limits, because sensitivity analysis of the former has too expensive computation. 3) The problem with a phenomenon of ill-conditioned load, which is similar to ill-conditioned stiffness matrix in the structural analysis, is not easy to get reasonable final topological structure, because the former is difficult to consider different influences between the loads with small forces and the loads with big forces, and some of topology paths of transferring small forces may disappear during the process of iteration. To overcome the above difficulties, some measures are adopted as follows:1) Topology optimization model is established by independent continuous mapping (ICM) method. 2) Based on the von Mises criteria in theory of elastic failure, all element’ s stress constraints are transformed into a structural energy constraint, namely, a global constraint substitutes for lots of local constraints. 3) The phenomenon of the ill-conditioned load is divided into three cases: (a) Ill-condition exists between load cases, but not within each load case; (b) Ill-condition exists within some load case; (c) Ill-condition exists not only between load cases, but also within some load case. (4) A strategy based on strain energy is proposed to adopt ICM method with stress globalization, and the problems of the three cases of ill-conditioned load mentioned above are solved in term of different complementary approaches one by one. Numerical examples show that the topology path of transferring forces can be obtained more easily by substituting global strain energy constraints for local stresses constraints, and the problem of ill-conditioned load can be solved well by the weighting method which takes structural energy as weighting coefficient.

TOPOLOGY OPTIMIZATION OF CONTINUUM STRUCTURES WITH DESIGN-DEPENDENT TIME-HARMONIC HYDRODYNAMICSURFACE PRESSURE

Topology Optimization of 3D Structures with Design-Dependent Loads

A new boundary search scheme for topology optimization of continuum structures with design-dependent loads

The Path-Engulfment Method for Topology Optimization of Structures

Topology optimization of fluidic pressure-loaded structures and compliant mechanisms using the Darcy method

Topological Optimization of Continuum Structures with Design-Dependent Surface Loading – Part I: New Computational Approach for 2D Problems

Efficient topology optimization for geometrically nonlinear multi-material systems under design-dependent pressure loading

TOPOLOGY OPTIMIZATION OF CONTINUUM STRUCTURES SUBJECTED TO SELF WEIGHT LOADS

Topology optimization of compliant mechanisms and structures subjected to design-dependent pressure loadings

On topology optimization of design-dependent pressure-loaded three-dimensional structures and compliant mechanisms

Topology optimization of surface flows

2D Minimum Compliance Topology Optimization Based on a Region Partitioning Strategy

Structural Dynamic Response Topology Optimization under Basic Harmonic Excitation

Topology optimization of laminated composite structures under harmonic force excitations

Topology Optimization of Continuum Structure With Globalization of Stress Constraints

Topological Optimization of Continuum Structures with Design-Dependent Surface Loading – Part II: Algorithm and Examples for 3D Problems

Topology optimization of binary structures under design-dependent fluid-structure interaction loads

Topology optimization with continuously varying load magnitude and direction for compliance minimization

Topology Optimization in Aircraft and Aerospace Structures Design

Solving Topology Optimization Problems Based on RAMP Method Combined with Guide-weight Method

Topology Optimization of Planar Heat Sinks Considering Out-of-plane Design-Dependent Deformation Problems