Abstract:The green wave coordinated control model has evolved from the basic bandwidth maximization model to the multiweight approach to an asymmetrical multiband model and a general signal progression model with phase optimization to improve the operational efficiency of urban arterial roads and reduce driving delays and the amount of exhaust gas generated by vehicles queuing at intersections. However, most of the existing green wave models of arterial roads are based on a single phase pattern and little consider the optimization of the combination of multiple phase patterns. Initial queue clearing time is also considered at the green wave progression line in the time–space diagram, which leads to a waste of green light time. This study proposes a coordination control optimization method based on an asymmetrical multiband model with phase optimization to address the abovementioned problem. This model optimizes four aspects in the time–distance diagram: phase pattern selection, phase sequence, offset, and queue clearing time. Numerical experiments were conducted using the VISSIM micro traffic simulation tool for intersections along Kunlunshan South Road in Qingdao, and the effect of green wave coordination was evaluated using hierarchical analysis and compared with the signal-timing schemes generated by the four models: the multiweight approach, the improved multiweight approach, an asymmetrical multiband model, and a general signal progression model with phase optimization. The results show that an asymmetrical multiband model with phase optimization obtains a total bandwidth of 314 s in both directions. In the outbound direction, average number of stops, average travel speed, average travel time, and average delay time improve by 16%, 7.9%, 17.9%, and 15.6%, respectively. In the inbound direction, they improve by 43.7%, 16.1%, 40.7%, and 36%, respectively. Polluting gas emissions and fuel consumption improve by 17.9%. The applicability of the optimization method under different traffic flow conditions is analyzed, and results indicate a clear control effect when the traffic volume is moderate and the turning vehicles on the feeder roads are few. This work can provide a reference for the optimization of subsequent arterial signal coordination and also has indirect significance for environmental protection to a certain extent.

An AHP-Based Performance Evaluation Model of Transportation Control System: the Experience from West Liaohe Rd., Dalian

A Two-Way Arterial Signal Coordination Method with Queueing Process Considered

Signal Optimization and Its Evaluation Method for Urban Freight Arterial

On-ramp Metering on Beijing Urban Expressway

On-ramp metering control strategy of urban expressway

A Signal Coordination Model for Long Arterials Considering Link Traffic Flow Characteristics

Novel Evaluation Method for Signalized Intersections

Optimizing Signal Controls for Urban Mixed Use Transport Arterial

Simulation of the Frontage Road Control Near the Expressway Exit Ramp

Simulation analysis of traffic signal control and transit signal priority strategies under Arterial Coordination Conditions

A Decentralized Model Predictive Traffic Signal Control Method with Fixed Phase Sequence for Urban Networks.

Ideas and Methods for Mixed Urban Traffic Control

Bus signal priority method at arterial signal progression

Improving Performance of Coordinated Signal Control Systems Using Signal and Loop Data

Arterial Coordination Control Optimization Based on AM–BAND–PBAND Model

Critical Traffic Volume Warrant of Signal Installing at Equal Weight Intersections

Online Performance Measurement Method Based on Arterial Infrastructure Data

Comparative study on simulation performances of CORSIM and VISSIM for urban street network.

Coordination Control Strategy of Urban Expressway On-ramp and Off-ramp

Using Analytic Hierarchy Process To Evaluate The Improvement Schemes Of The Maoliling Tunnel Based On The Vissim Simulation

An Optimized Signal Control Method for a Freight Arterial Transport System