Abstract:The objective of the LuFo VI-1 project CATeW (Coupled Aerodynamic Technologies for Aircraft Wings) consists in multifidelity analyses to assess the potential for aerodynamic efficiency increase by combined application of hybrid laminar flow control and variable camber technologies to the wing of a transonic transport aircraft. Individually, both technologies have proven to lead to major aerodynamic drag reductions. An evaluation of the coupled technologies is, therefore, expected to show an even higher potential due to synergy effects. To derive conclusions on system level, low-fidelity (LowFi) overall aircraft design methodologies will be applied for the analysis of a medium haul reference aircraft in the course of the project, while complex aerodynamic phenomena are modelled with high-fidelity (HiFi) computational fluid dynamics methods. The paper at hand presents results of aerodynamic analyses on both fidelity levels for the wing of the turbulent reference configuration CATeW-01, featuring the technology combination as a retrofit. Furthermore, this work encompasses adaptations and implementations performed within both the LowFi and HiFi toolchains. The LowFi toolchain already incorporates several modules for the proposed technology combination. A short presentation of the LowFi-toolchain is given, along with the modeling approach in the HiFi framework using mesh deformations and a mass flux boundary condition. Comparative studies of the turbulent flow field around the wing show good agreement of predicted load distributions in both numerical frameworks, studies based upon the HiFi approach attest the potential for efficiency increase due to the variable camber technology, incorporated by means of Adaptive Dropped Hinge Flap (ADHF) deflections. Considering the coupled application, four different constant suction mass flow rates are examined, where the maximum mass flow causes laminar flow extending over the entire suction panel, thus moving the transition location from the wing's leading edge to the end of the suction panel. When being coupled with ADHF deflections, again the variable camber technology leads to a reduction of the wing's pressure drag component with the simultaneous application of boundary layer suction further promoting drag reduction with increasing suction rate. While the combined application shows no mutual inhibition, major reciprocal effects are not directly observable when applying the combination as a retrofit to the reference configuration CATeW-01. This is mainly attributed to the limited extend of laminar flow, thus indicating the necessity for optimization in wing geometry and operating parameters, to achieve extensive areas of laminar flow and to promote the aspired synergy effects.

Analysis of two configurations for a commercial WIG craft based on CFD

The Inherent Stability Characteristics of a Wing-in-Ground (WIG) Craft in Various Ground Effect Regions

Structure Designation and Dynamic Model Analysis of Folding Wing for Underwater Vehicles

The Compressibility Effects on the Inherent Stability of Wing-In-Ground Crafts

Constraint analysis methodology for ground-effect vehicle conceptual design

On Unsteady Effects in WIG Craft Aerodynamics

The design of a four-seat reverse delta WIG craft

OPTIMIZATION OF WAVERIDER CONFIGURATIONS BY CFD CALCULATION AND GENETIC ALGORITHM

Numerical Investigation of Auto-Pitch Wing-in-ground Effect Oscillating Foil Propulsor

Parametric Design Method and Lift/Drag Characteristics Analysis for a Wide-Range, Wing-Morphing Glide Vehicle

System Design and Characteristics Analysis of a Variable-sweep and Variable-span Wing-body

Preliminary Analysis of the Stability and Controllability of a Box-Wing Aircraft Configuration

A Computational Fluid Dynamics Method for Resistance Prediction of the Floating Hull of Wave Glider

Numerical analyses of a reference wing for combination of hybrid laminar flow control and variable camber

Aerodynamic Analysis and Simulation for a Z-Shaped Folding Wing UAV

Wing design optimization and stall analysis with Co-flow Jet active control

Hydrodynamic Performance Of A Current Energy Generator Based On Wig

Design and analysis of the air-breathing aircraft with the full-body wave-ride performance

An Inverse Design Method for Wing Shape Optimization Guided by Spanwise Lift Distribution

Performance and Stability Analysis for Zju Glider

Aerodynamic Analysis of a Flapping Wing Aircraft for Short Landing