Abstract:Controlling current at critical conduction mode (CRM) is an effective way to achieve zero voltage switching (ZVS) of switches for inverters. However, the higher reverse inductor current and fixed deadtime in fully digital soft-switching control, such as reverse current boundary-based (RCB-based) schemes, lead to higher rms inductor current and higher power losses. Besides, the digital control frequency for CRM-based inverters is not well designed, resulting in the contradiction between high performance and high digital calculation burden. Therefore, this article proposes a fully digital soft-switching control based on the variable <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">off</small> -time and deadtime with an optimized designed digital control frequency. First, the variable <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">off</small> -time and deadtime design guidelines are addressed with the established mathematical model of the CRM-based inverter. Then, the power losses of the inverter with different digital control frequencies and control schemes are quantitatively analyzed and compared. Finally, a 1 kW single-phase three-level neutral-point-clamped grid-tied inverter was built. Experimental results show that the proposed scheme can achieve the ZVS turn- <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small> of switches without additional components, and the maximum efficiency is 98.3%. Compared with the RCB-based scheme, the proposed method achieves higher efficiency with the same hardware cost.

The evaluation of control strategies for Auxiliary Resonant Commutated Pole inverter

Divided-fixed Timing Control Method for Auxiliary Resonant Commutated Pole Soft-switching Inverter

Minimum Current Control for Under-Resonant Dual-Bridge-Series-Resonant Converter

Analysis and Design of a Control Strategy for Wide-Range ZVS of Isolated Bidirectional Dual-Bridge Series Resonant DC/DC Converters

Model Predictive Control for Quasi-Z Source Inverters with Improved Thermal Performance

Research on Master-slave Paralleled Middle-Frequency Inverters' System Based on Average Power Control Strategies

Control of ZVS Single-Phase Grid Inverter with Higher Power Quality

Comparison Of Control Strategies For Active Power Filter In Three-Phase Four-Wire Systems

A Novel Midpoint Voltage Balance Control Strategy Based on Resonant Current Adjustment for Auxiliary Resonant Commutated Pole Inverter

An Improved Auxiliary Resonant Pole TNPC Inverter and Its Modulation Strategy

Hybrid SVPWM Modulation Strategy for Auxiliary Resonant Commutated Pole Inverter

Research on auxiliary resonant commutated pole inverter for driving brushless DC motor

A Symmetrical Control Scheme for a Resonant Switched-Capacitor Converter with Inverted Output Voltage

Adaptive Soft-Switching Control of Active-Clamping Three-Phase Inverters

Three-level photovoltaic inverter technology based on repetitive control

Research on an Asymmetric Fault Control Strategy for an AC/AC System Based on a Modular Multilevel Matrix Converter

A Synchronous Auxiliary Resonant Commutated Pole Soft-Switching Inverter With Improved Load Adaptability

Control Strategy for Open Winding PMSM System Supplied by the Z-source and Voltage Source Integrated Converters

Research on strategy of load-side resonant soft-switching inverter based on interconnection and damping assignment-passivity based control

ARCPI and Its Applications in Multi-Level Inverter

Variable OFF-Time and Deadtime Scheme With Optimized Control Frequency for Soft-Switching Single-Phase Inverters