Investigation of dynamic three–point bending fracture properties of SCB sandstone
Yu Zhou,Hao Zhou,Shizhuo Zou,Wanhong Guo,Shichao Jiang,Yongsheng Zhang,Linyun Qian
DOI: https://doi.org/10.1016/j.tafmec.2023.104232
IF: 4.374
2023-12-13
Theoretical and Applied Fracture Mechanics
Abstract:The stress intensity factor (SIF) is not only an important parameter in the field of fracture mechanics but also a key indicator reflecting the strength of the stress field at the crack tip. Therefore, this paper uses the Split–Hopkinson–Pressure–Bar (SHPB) device to conduct dynamic fracture experiments on semi–circular bend (SCB) sandstones of different fracture modes and then uses an experimental–numerical method to simulate the dynamic loading process to explore the changes law in SIF. Finally, combined with the high–speed digital image correlation (HS–DIC) technology, the fracture characteristics of SCB sandstones are studied. The results show that the rising rate of dissipated energy acting on the specimen fracture and damage increases rapidly when it is close to dynamic fracture, which makes the dynamic SIF also get a substantial increase, and the influence of dissipated energy on dynamic SIF is seen to be very strong. Moreover, prior to the occurrence of dynamic initiation fracture, the damage to the specimen is primarily triggered by microscopic tensile effects at the tip of the preset crack, which results in the value of K I always being greater than K II before the dynamic fracture occurs. Meanwhile, the distribution curve of dynamic SIF exhibits better symmetry or a trend towards symmetry compared to the distribution curve of static SIF. This suggests that the tip of the preset crack distributes with more uniform tensile and shear stresses during dynamic loading. Using the HS–DIC technique, when the specimen occurs dynamic pure mode I initiation fracture, there was a good symmetrical trend in both the vertical strain around the fracture crack and the horizontal displacement field at the specimen. However, when specimens occur dynamic mixed mode I/II initiation fracture, the horizontal displacement fields showed asymmetry, and the specimens all suffered varying degrees of shear damage.
engineering, mechanical,mechanics