Abstract:The assumed mode method (AMM) is widely used for dynamical modeling but faces increasing challenges in developing low-dimensional and high-precision models of complex structures for investigations of nonlinear dynamical responses and active vibration control. This is mainly because the current complex structure has an increasing number of components, each of which needs to be discretized by multiple assumed modes in dynamical modeling, leading to increasing degrees of freedom for the system. To address this issue, this paper proposes a dimension-reduced method based on the assumed mode weighting method, referred to as Mode Weighting Method (MWM). The modeling process of a multi-beam structure is fully presented as an example to show the strategy of the MWM. During this process, the assumed mode (AM) model (the dynamic model derived in terms of a set of assumed modes) is developed first where the joints of the structure between its components are considered as artificial springs and each component is discretized by its vibration modes without constraints. The components of the eigenvector of the characteristic equation derived from the AM model are taken as the weighting coefficients to get the approximate analytical global modes of the structure by multiplying the corresponding assumed modes. Consequently, a nonlinear dynamic model with a few degree of freedom is obtained by discretizing the structure with the weighted modes. Moreover, a technique for simply obtaining the weighted mode (WM) models by directly processing the AM model through a transformation matrix is presented. To validate the proposed method, the simulations on the natural characteristics and the dynamical responses for both linear and nonlinear models, are performed respectively based on the WM and the finite element models, where both results are well matched each other. This work provides a new way of developing advanced dynamical modeling methods for structural dynamics design, optimization, and active vibration control.

Vibration Modeling of a Partially ACLD Beam with Assumed Mode Method

A Ductility-Centred Analytical Model for Axially Restrained Double-Span Steel Beam Systems Subjected to Sudden Columns Loss

Cohesive Cracking Simulation of Concrete Using Effective Modulus

Vibration Analysis and FEM model of Hollow Circular Beam with Constrained Damping Layer

A DVA-Beam Element for Dynamic Simulation of DVA-Beam System: Modeling, Validation and Application

A New Quantitative Acoustic Emission Model for Damage Characterization of Composite Laminates Using Original Waveforms

Semi-analytical analysis on free vibration of cantilever beam with particle damping based on multiscale method

Physical Essence and Influence of Model Parameters on Dynamic Response of Rayleigh Damping

An electro-mechanical impedance model of a cracked composite beam with adhesively bonded piezoelectric patches

Dynamic Modeling and Vibration Suppression of a Rotating Flexible Beam with Segmented Active Constrained Layer Damping Treatment

Structural modal identification and MCMC-based model updating by a Bayesian approach

Beam Element Model Analysis of Composite Beam with Constrained Damping Layer

Nonlinear dynamical modeling and response analysis of complex structures based on assumed mode weighting

Electromechanical Impedance Response of a Cracked Functionally Graded Beam with Imperfectly Bonded Piezoelectric Wafers

Influence analysis of control signal phase on the vibration reduction effect of active constrained layer damping

Modeling the bending vibration of cross-laminated timber beams

A modeling method for vibration analysis of cracked laminated composite beam of uniform rectangular cross-section with arbitrary boundary condition

Global Finite Element Model for Vibration Analysis to Circular Beam with Constrained Damping Layer

Analysis of dynamic modeling and power flow of ABH laminated composite thin beam with elastic boundaries

A New Method of Obtaining Modal Sensitivity for Damage Location in Beam Structure

A Beam with Arbitrarily Placed Lateral Dampers: Evolution of Complex Modes with Damping