A Pipe Network Skeleton Method Based on GIS Network Analysis Technologies

Tao,Kunlun Xin,Suiqing Liu,Xinyu Zhang

DOI: https://doi.org/10.1061/41073(361)56

2009-01-01

Abstract:During the process of urbanization, many of the existing urban water-supply systems need to be expanded to meet the increasing urban water consumption. A precise water network hydraulic model is necessary to perform water network expansion plan. Building a hydraulic model is normally based on the established GIS of current water network, which contains quite huge quantity of information about pipes with various diameters and water facilities including pumps, valves and hydrants. However, much of those data in water network GIS is not necessary for hydraulic modeling and simulation. This paper proposed an auto skeleton method which based on the ArcGIS utilities network analysis toolbox. Firstly the geometric network was established in which the flow directions and the water sources are determined as well as the topology of the water network. Secondly, the branches of network were identified step by step and trimmed provided that the water demands in the branches were accumulated to the root junction of the branches. Thirdly, the pipe loops which can be deleted in the network were also indentified and deleted with demands preserved to the corresponding junctions. Finally, the pipes with same diameters which located at a non-branch route were merged providing the lengths of the merged pipe were not beyond the present value. The proposed method can simplify a complicated network to a hydraulic-equivalent network model in which about 50–60% of pipes were removed, and huge plenty of tedious manual work were thus avoided.