Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

RESEARCH ON SELECTION OF STRESS VARIABLES OF CONSTITUTIVE MODEL FOR UNSATURATED SOILS

Discussion on Selection Principle of Stress Variables of Unsaturated Soil

Effective stress in soils under different saturation conditions

Constitutive relations and deformation calculation for unsaturated soils

Influences Affecting the Soil-Water Characteristic Curve

Physical Derivation of Effective Stress from Balance Law and Experimental Evidence

An effective stress-based approach to modeling the hydro-mechanical behavior of unsaturated soils

RESEARCH ON PATTERN TRANSITION CURVES AND THE PARAMETERS IN STRESS-STRAIN RELATIONSHIP OF SOILS

A constitutive model for structured soils under saturated and unsaturated conditions

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

Behaviors, constitutive models and numerical simulation of soils

A PRACTICAL CONSTITUTIVE MODEL OF SOIL CONSDIERING THE BEHAVIOR AT SMALL STRAINS

COMPARISON STUDY ON RHEOLOGICAL CONSTITUTIVE MODELS

Numerical Analysis Of Unsaturated Excavation By Using Suction Stress

Mechanical Properties and Constitutive Model of Artificial Frozen Sandy Soils under True Triaxial Stress State Conditions

Modeling Of Stress-Strain Behavior Of Soft Clay Under Cyclic Loading

VARIATION OF THE SHEAR STRENGTH OF XIAMEN UNSATURATED RESIDUAL SOILS WITH WATER CONTENT

Modelling plasticity of unsaturated soils in a thermodynamically consistent framework

Some Problems in Researches on Constitutive Model of Soil

A Thermodynamic Constitutive Model for Undrained Monotonic and Cyclic Shear Behavior of Saturated Soils

Experimental and discrete element modeling study on suction stress characteristic curve and soil–water characteristic curve of unsaturated reticulated red clay