Abstract:For the research on real-time accurate testing technology for the explosion point spatial coordinate of munitions, its currently commonly used methods such as acoustic–electric detection or high-speed imaging are limited by the field conditions, response rate, cost, and other factors. In this paper, a method of spatial coordinate testing for the explosion point based on a 2D PSD (position-sensitive detector) intersection is proposed, which has the advantages of a faster response, better real-time performance, and a lower cost. Firstly, a mathematical model of the spatial coordinate testing system was constructed, and an error propagation model for structural parameters was developed. The influence of the position of the optical axes' intersection as well as the azimuth angle and pitch angle on the test accuracy of the system was simulated and analyzed, thus obtaining the distribution and variation trend of the overall error propagation coefficient of the system. Finally, experiments were designed to obtain the test error of the system for validation. The results show that the system test accuracy is high when the azimuth angle is 20°–50°, the overall error propagation coefficient does not exceed 48.80, and the average test error is 56.17 mm. When the pitch angle is −2.5°–2.5°, the system has a higher test accuracy, with the overall error propagation coefficient not exceeding 44.82, and the average test error is 41.87 mm. The test accuracy of the system is higher when the position of the optical axes' intersection is chosen to make sure that explosion points fall in the region of the negative half-axis of the Zw-axis of the world coordinate system, with an overall error propagation coefficient of less than 44.78 and an average test error of 73.38 mm. It is shown that a reasonable selection of system structure parameters can significantly improve the system test accuracy and optimize the system deployment mode under the long-distance field conditions so as to improve the deployment efficiency.

Research On The Testing Method Of Fuze Arming Distance Based On Kinematical Principle

Simulation and Test of a MEMS Arming Device for a Fuze

Feasibility Research of Defect Testing for Basin Insulator Based on Ultrasonic Guided Wave

Remote Collaborative Pseudo-dynamic Tests of a Ten-story Concrete Filled Steel Tubular Composite Frame

Research on Proximity Fuze Starting Strategy Based on Angle Measured by Anti-radiation Missile Seeker

Test and Improvement of a Fuze MEMS Setback Arming Device Based on the EDM Process

Innovation of control technology for smart fuzes: precise detonation and efficient damage via a ternary cascade controller

Application of Computer Finite Element Simulation to the Quantitative Inspection of Flaw MFL

Analysis of the influence of different initial velocities on dynamic performance of multi-layer hard target penetration process

Research on the Equivalent Impact Test Method for Different Pulse Widths Based on Micro-Electro-Mechanical System Devices

Distance Cutoff Characteristic of Multi-sinusoidal FM-CW Fuze

Analysis and experiment of stress concentration in penetration fuze buffer materials under stress wave incursion

Research on fuze microswitch based on corona discharge effect

Research on Multiphysics-Driven MEMS Safety and Arming Devices

Error Analysis and Optimization of Structural Parameters of Spatial Coordinate Testing System Based on Position-Sensitive Detector

High-speed rotating mechanism based on multi-sensor data fusion end face displacement determination method

A Calculating Method for the Brake Drag Mechanism's Opening Time of Range Correction Fuze

Research on the Signal Processing Technique for Semi-active Laser Proximity Fuze for Small Caliber Shell

Advancements in research on high-overload impact-buffering protective materials

Design of a Multifunctional Friction-test Instrument and Its Experiment

A multi-source information fusion layer counting method for penetration fuze based on TCN-LSTM