Abstract:Abstract Using steam as a heat carrier and working media has merits to increase electric efficiency up to 60% and decrease NOx emission to single-digit compared to dry gas turbine cycles. These attribute primarily to the physical properties of steam as having high heat capacity to reduce local flame temperature, and hence reduce emissions by inhibiting the thermal NOx forward reaction rate. In this work, ultrahigh steam content with a steam-to-air mass ratio of up to 40% is premixed with methane–air mixture before entering into a swirl-stabilized high pressure (HP)-burner for combustion. A significant change of flame from V-shape (attached) to M shape (detached) is observed through a transparent combustion chamber whilst changing steam content. The measurement of chemiluminescence OH* is conducted with an intensified CCD-camera bandpass filtered at 320 nm. Following these measurements, large eddy simulation (LES) is used to capture reacting flow features. Reasonably well agreements between experimental data and numerical results are obtained for both attached and detached flames in terms of the OH* distribution. Slight inconsistency of OH* intensity is mainly due to uncollected wall temperature, which leads to either over- or underprediction of chemical reaction rate depending on the experimental flame positions. Distributed flame front is clearly identified with LES for wet methane combustion associated with 35% steam-to-air ratio corresponding to a high Karlovitz number flame. Slightly unstable combustion is observed when the steam-to-air ratio exceeds 40% featuring an onset of flame blow-off. In addition, interaction between precessing vortex core (PVC) and the flame is presented for different level of steam dilution, and conclusions are drawn regarding the flame stabilization. The in-depth understanding of the ultrawet combustion is an important step toward the use of sustainable, steam-diluted biosyngas for electricity production.

EXPERIMENTAL STUDY ON THE THERMOELECTRIC CONVERSION CHARACTERISTICS BASED ON METHANE COMBUSTION

Experimental study of a mesoscale combustor-powered thermoelectric generator

Study of the Experiment on Thermoelectric-microcombustors

Multiphysics Co-Simulation and Experimental Study of Deep-Sea Hydrothermal Energy Generation System

Experimental Study on a High Efficient and Ultra-Lean Burn Meso-Scale Thermoelectric System Based on Porous Media Combustion

Experimental and Numerical Investigation of Ultra-Wet Methane Combustion Technique for Power Generation

Study on the Combustion and Thermoelectric Conversion Characteristics of Micro-Combustors

Overall numerical simulation of chemical-thermal-electric conversion for an all-in-one thermoelectric generator based on micro scale combustion

Experimental and numerical studies of thermal power conversion and energy flow under high-compression ratios of a liquid methane engine (LME)

Numerical Study on the Characteristics of Methane Hedging Combustion in a Heat Cycle Porous Media Burner

Numerical Study on Thermoelectric Power Generator in Combustor

Measurement and Analysis for Performance of Micro-thermoelectric Generator

Experimental investigation of a micro-combined cooling, heating and power system driven by a gas engine

Thermal and emission performance of CH4 and H2–CH4 thermophotovoltaic micro-power generators

Study on Thermoelectric Generators Based on Exhaust Gas and Cryogenic Fuel for LNG Vehicles

Combustion enhancement and performance analysis of T-shaped rod-assisted methane/air combustors for micro-thermophotovoltaic systems

Performance and Reliability of Thermoelectric Conversion Using a Crooked Thermosyphon to Enhance Heat Transfer from Coal Fires

Research on combustion performance of a micro-mixing combustor for methane-fueled gas turbine

Experimental study of methane/air combustion in a Swiss-roll miniature combustor

Experimental Study on Ultra-Low Concentration Methane Regenerative Thermal Oxidation

Experimental Investigations on Combustion Characteristics of Syngas Composed of CH 4 , CO, and H 2