Abstract:The construction of a tunnel portal faces the challenges of complex geological conditions, such as shallow burial and asymmetrical loading. In addition, the adverse effects of factors such as the layout form of the tunnel must also be considered. Thus, the construction of portals has always been the focus of tunnel engineering. Under the coupling of multiple adverse factors, such as complex geological conditions and special layout form, the tunnel portal is prone to excessive deformation, supporting structural cracking, and even collapse during excavation. In this study, a shallow buried and asymmetrically loaded tunnel with a small clear-distance in northwest China was considered as an engineering case. To address the distresses of slope instability, peeling off and block falling of primary support concrete, and cracking of secondary lining concrete in the tunnel portal construction, combined with field investigations, statistical analysis, numerical simulation, and deformation monitoring, the failure mechanism of supporting structures was deeply studied and corresponding treatment measures were proposed. The research results indicated that loose and broken gravel soil in the shallow buried section, asymmetrical loading, surface water infiltration, and short construction spacing between the two tunnels were the main triggers of supporting structures failure. Affected by topographic bias, the loose load generated by the surrounding rock on the deeply buried side squeezed the entire tunnel to the shallow buried side after portal excavation. This deformation trend became more significant after the gravel soil deteriorated by water immersion. The retaining wall produced a clockwise rotation deformation around the wall corner in the process of limiting the tunnel deviation, and the local wall body cracked owing to excessive tensile stress. The primary support concrete and secondary lining concrete produced excessive asymmetrical deformation because of significant asymmetrical loading. Concrete with excessive deformation was cracked by obvious tensile or shear stresses. The subsequent tunnel excavation had a significant negative impact on the stability of the prior tunnel. Combining the failure mechanism of the supporting structures and the characteristics of the continuous development of cracks, the treatment measures of ‘stabilize the stratum first and then treat the cracks’ were proposed, including the backfilling and tamping the shallow buried side at tunnel portal, reinforcing the interlaid rock by ground surface grouting, setting intercepting ditch at the slope top, and staggering a certain safe excavation distance between the following tunnel and the prior tunnel. Field monitoring and patrol inspection results indicated that the proposed treatment measures achieved the expected results. The research results can provide corresponding construction experience and suggestions for similar projects in future.

Dynamic Behavior of Portal Part of Traffic Tunnel in High-Intensity Earthquake Area

Instability Mechanism of Shallow Tunnel in Soft Rock Subjected to Surcharge Loads

Failure mechanism and treatment measures of supporting structures at the portal for a shallow buried and asymmetrically loaded tunnel with small clear-distance

Shaking Table Test on the Tunnel Dynamic Response under Different Fault Dip Angles

Dynamic Responses of Bridge–Tunnel Overlapping Structure for High-Speed Railway Under Different Seismic Excitations

Dynamic Interaction and Failure Mechanism in Tunnel-Slope Systems: Mitigation Insights from Shaking Table Tests and Numerical Analysis

Dynamic Response Characteristics and Instability Mechanism of High-Steep Bedding Rock Slope at the Tunnel Portal in High-Intensity Seismic Region

Dynamic Response of Shallow-Buried Small Spacing Tunnel with Asymmetrical Pressure: Shaking Table Testing and Numerical Simulation

Shaking table test on the seismic response and reinforcement measures of double-arch tunnels in mountainous areas

Seismic energy response and damage evolution of tunnel lining structures

Influence of relative distance between fault and tunnel on dynamic response of tunnel: An experimental and numerical investigation

Dynamic Responses of Steep Bedding Slope-Tunnel System under Coupled Rainfall-Seismicity: Shaking Table Test

Model test study on the dynamic failure process of tunnel surrounding rocks in jointed rock mass under explosive load

Tunnel failure mechanism during loading and unloading processes through physical model testing and DEM simulation

Seismic response and deformation mechanism of near-fault deep tunnels in a strong earthquake area

The Large-Scale Shaking Table Model Test of the Shallow-Bias Tunnel with a Small Clear Distance

Examination of Longitudinal Seismic Vulnerability of Shield Tunnels Utilizing Incremental Dynamic Analysis

Shaking Table Test on Seismic Response of Tunnel-Soil Surface Structure System considering Soil-Structure Interaction

Dynamic damage and response characteristics of the tunnel by FEM modeling and field trials

Simulation analysis of seismic dynamic response of small interval tunnel in deep backfill area based on model test

Response and failure mechanism of utility tunnel with flexible joints under reverse fault: An experimental, numerical, and analytical investigation