Abstract:This study presents a novel roller piston pump,in which a cam guide-roller type rolling support is adopted to replace the sliding pair support of the swash plate-slipper pair to achieve the oil suction and discharge of the piston cavity.In addition,the shaft distribution is used to replace the original valve plate distribution and the driving shaft is used as the distribution shaft to remove the valve plate structure,which greatly simplifies the design of the axial piston pump.Such a configuration largely reduces the number of sliding friction pairs of the pump,and avoids the influence of the sliding friction pair on it under high-speed and variable-speed conditions.Firstly,mathematical models of the mechanical and volumetric efficiencies of the roller pump are deduced respectively through force analysis and the compressibility equation.Based on the numerical simulation of MATLAB and AMESim,the effects of load pressure and rotational speed on mechanical and volumetric efficiencies are studied respectively,and it is verified that the roller pump has no structural flow pulsation.The prototype pump is then designed and built,along with a special test rig.The outlet pressure,outlet flow,and torque of the pump under different load pressures and rotational speeds are measured,and the mechanical and volumetric efficiencies of the prototype pump under various load pressures and rotational speeds are obtained.The experimental results are in good agreement with the simulated analysis.When the load pressure is 8 MPa and the speed is 5000 r/min,the mechanical and the volumetric efficiencies are 85.5%and 96.8%,respectively.When the speed is increased to 10000 r/min,the mechanical and the volumetric efficiencies are 66.7%and 95.6%,respectively.The experimental results show that the proposed roller piston pump has excellent efficiency under wide-speed and high-speed conditions and can be a potential solution as a fuel pump in aerospace fuel systems.

Research on improvement of reciprocating seal life of special piston pump

Analysis on dynamic experimental system of lubrication film properties of friction pairs in axial piston pump

Study on Friction Characteristics of Slipper Pair of Large Displacement High-Pressure Piston Pump

Investigation on the Radial Micro-Motion about Piston of Axial Piston Pump

Research on Oil Film Forming of Port Pair in Axial Piston Pump and its Prediction

Real-time Measurement on Lubrication Characteristic Parameters of Plane Port Pair in Axial Piston Pumps

Research on Wear Prediction of Piston/cylinder Pair in Axial Piston Pumps

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

THE TRANSITION OF WEAR AND LEAKAGE CHARACTERISTICS OF THE CYLINDER BLOCK/VALVE PLATE INTERFACE IN A WIDE RANGE OF OPERATING CONDITIONS

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Investigation on Structural Optimization of Anti-Overturning Slipper of Axial Piston Pump

Theoretical and Experimental Investigation on the Efficiency of a Novel Roller Piston Pump

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Study on Friction and Wear Performance of Sliding Metal Seal Materials Under Reciprocating Motion

A study on improving friction and wear performance of bearing bush in radial piston hydraulic motor

Dynamic failure analysis of static seals under pressure fluctuation in an ultrahigh-pressure water piston pump

Analysis of the Flow Dynamics Characteristics of an Axial Piston Pump Based on the Computational Fluid Dynamics Method

Volumetric efficiency degradation prediction of axial piston pump based on friction and wear test

Transient sealing characteristics of Glyd-ring in the high water-based piston pair under reciprocating pump conditions

Performance Optimization for High Speed Axial Piston Pump Considering Cylinder Block Tilt

Improvement Design of a Vertical Double-stage Self-priming Pump