Abstract:The turbine of an aircraft engine involves a multi-disciplinary coupling problem that interacts among the flow field, temperature field and solid structure. This study focuses on conducting numerical simulations of a second-stage low-pressure turbine incorporating a disc cavity. Two different multi-disciplinary coupling approaches, namely Conjugate Heat Transfer and Thermal-Fluid-Structure Interaction, are employed to compare the disparities in aerodynamic performance and flow field characteristics. This study aims to illuminate the characteristics of solid deformation and the underlying mechanisms influencing the flow field. The results indicate that the radial deformation of the rotor blade is predominantly governed by thermal load, while the axial and twist deformations are driven by the aerodynamic load. Additionally, circumferential deformation is influenced by both aerodynamic and centrifugal loads. As a result of these deformations, the reduction in the high-loss region at the tip of the rotor blade leads to a localized enhancement in efficiency, while the intensification of secondary flow at other positions along the blade height leads to a reduction in local efficiency. In general, although the deformation at the tip of the rotor blade is the largest, approximately 4.1 mm, the mass flow rate at this location accounts for a small percentage, approximately 3% of the overall flow. Therefore, the increase in local efficiency at the blade tip is insufficient to compensate for the decrease in efficiency at other positions. As a result, the turbine's efficiency exhibits a decreasing trend after deformation, with an average reduction of 0.53% compared to before deformation. Moreover, the radial and axial clearances at the rim are influenced by the centrifugal and aerodynamic loads respectively. Under hot-state, changes in the clearance at rim can reduce gas ingestion, thereby enhancing the cooling effect on solid components inside the disc cavity. The radial clearance at the sealing teeth is primarily influenced by centrifugal load. During hot-state, a reduction in the radial clearance at the sealing teeth leads to an increased accumulation of coolant air at the bottom of the disc cavity, thereby enhancing both cooling and sealing capabilities. Ultimately, the conclusions about the multi-disciplinary coupling mechanisms between internal flow heat transfer and solid deformation provide theoretical insights for designing high-performance turbines.

Numerical Simulation of Fluid-solid Coupling of Blades in the Last Stage of a Steam Turbine

Numerical Simulation for Vibration of Interferometric Probein Wet Steam Flow Field

The Effect of High-Speed Steam Discharged from the Bypass Diffusers on Low-Pressure Turbine Blades

C207 applications of higher-order accurate computational fluid dynamic method to steam turbine blade designs

Numerical Simulation and Characteristic Calculation of Hydrodynamic Coupling

Structure and Modal Analysis of the Last Stage Blade in Steam Turbine under Low Volume Flow Conditions

THREE DIMENSIONAL VISCOUS FLOW NUMERICAL ANALYSIS OF STALL FLUTTER IN STEAM TURBINE BLADES

Numerical Calculation and Experiment of High-power Variable Speed Hydrodynamic Coupling

Numerical Simulation of Aeroelastic Response in Compressor Based on Fluid-Structure Coupling

Computation of Stress Distribution in a Mixed Flow Pump Based on Fluid-Structure Interaction Analysis

Vibration characteristics and life prediction of last stage blade in steam turbine Based on wet steam model

Dynamic simulation of nozzle structure based on thermal-fluid-solid coupling analysis

Fluid–Structure Coupling Analysis of the Stationary Structures of a Prototype Pump Turbine during Load Rejection

Research on multi-disciplinary coupling mechanism between internal flow heat transfer and solid deformation in turbine

Partitioned Coupled Heat Transfer Fluid-Structure Interaction for Transient and Steady State Analysis of Aero Engines Applications

Numerical Simulation of Fluid-Structure Coupling for a Multi-Blade Vertical-Axis Wind Turbine

Numerical Simulation of the Two-Phase Flows in A Hydraulic Coupling by Solving Vof Model

ANALYSIS ON FLOW SEPARATION CHARACTERISTICS OF LAST STAGE BLADE IN STEAM TURBINE UNDER SMALL VOLUME FLOW CONDITION

Analysis on strength performance of the last stage blade in steam turbine under low mass flow conditions

Numerical Simulation of Turbine Stage with Cooling Gas Injection

Analysis of Dynamic Stresses in Kaplan Turbine Blades