Abstract:The thermal effect of a single-dielectric-barrier-discharge plasma actuator under steady actuation is numerically investigated. A new actuator model is proposed and validated using experimental data. A discrete Galerkin method based on high-order flux reconstruction schemes is employed to solve the flow governing equations and the actuator model equations on unstructured quadrilateral grids. By comparing the induced heated and cold flow fields of the actuator with and without a plasma thermal source, its thermal effect is revealed. The actuator generates a thermal wall jet with rich vorticity, forming a monopolar starting vortex with a high-temperature and low-density core. Over time, the starting vortex becomes unstable and transforms into a dipole. Actuator heating enhances jet velocity and width, as well as vortex stability, while slowing down vorticity generation. The relative change in density and temperature fields due to actuator heating is four orders of magnitude greater than that without actuator heating. Additionally, the actuator heating causes the background thermodynamic fields to increase approximately linearly with time. Two stages in the actuator's thermal effect are distinguished due to time accumulation. Initially, the actuator heating minimally affects the monopolar starting vortex motion, and the temperature and density fields are treated as passive variables driven by the velocity field. During this stage, the momentum and thermal effects of the actuator can be studied separately. However, after the starting vortex becomes unstable, the actuator heating significantly impacts its motion and morphology, and these two effects are coupled with each other.

Experiment on the Induced Airflow Acceleration by Plasma Aerodynamic Actuation

EXPERIMENTAL INVESTIGATION ON INDUCED FLOW VELOCITY OF PLASMA AERODYNAMIC ACTUATION

Investigation on the acceleration characteristic by plasma aerodynamic actuation

PIV investigation on flow induced by plasma aerodynamic actuation

Experimental Investigation of Plasma Actuator's Configuration on Acceleration Effect

Flowfield induced by a plasma synthetic jet actuator with low exit inclination angle under low ambient pressure

Experimental Investigation of Hypersonic Flow and Plasma Aerodynamic Actuation Interaction

Experimental Investigation into Characteristics of Plasma Aerodynamic Actuation Generated by Dielectric Barrier Discharge

Experimental Investigation on the Characteristics of Sliding Discharge Plasma Aerodynamic Actuation

Thermal Effect on the Flow Induced by a Single-Dielectric-barrier-discharge Plasma Actuator under Steady Actuation

Discharge Characteristics and Acceleration Effect of Symmetric Plasma Aerodynamic Actuators

Study of Flow Induced by Sine Wave and Saw Tooth Plasma Actuators

Experimental Characterization of the Plasma Synthetic Jet Actuator

Experimental Investigation of Nanosecond Discharge Plasma Aerodynamic Actuation

Numerical Simulation and Experimental Validation of Pulsed Nanosecond Plasma Aerodynamic Actuation in Air Under Atmospheric Pressure

Influence of Excitation Voltage Waveform on Dielectric Barrier Discharge Plasma Aerodynamic Actuation Characteristics

Experimental Investigation on Airfoil Suction Side Flow Separation by Pulse Plasma Aerodynamic Actuation

Study on propagation mechanisms of the actuations generated by plasma synthetic jet actuator in a supersonic flow

Streamwise and Spanwise Plasma Actuators for Flow-Induced Cavity Noise Control

Experimental Investigation on Compression Ramp Shock Wave/boundary Layer Interaction Control Using Plasma Actuator Array

Shock Wave-Boundary Layer Interactions Control by Plasma Aerodynamic Actuation