Abstract:High-voltage pulsed-DC can be used to deposit films on the inner surfaces of tubes and pipes. However, the characteristics of the plasma discharge in the tubes and mechanisms of film deposition are not well understood. In this study, a discharge is formed in a metal tube inserted with a coaxial anode by microsecond (μs) pulsed power to explore the influence of the pulse parameters on the plasma characteristics, including the temporal and spatial evolution near the tube walls experimentally and by simulation. The discharge waveform is monitored by a voltage-current probe to analyze the impact of the electrical characteristics on the plasma. The plasma properties are diagnosed by a Langmuir probe and numerically calculated by the fluid model. The source voltage and current jointly influence the plasma density and electron temperature, and secondary electron emission by energetic ion bombardment affects not only the distribution of electron density measured by the probe, but also the temporal distribution during the pulse-on and pulse-off time. The electron temperature varies conversely with the density from the plasma zone to the cathode suggesting the typical glow discharge in the pulsed-DC tube. Secondary electron emission is created at a higher discharge frequency, and a sustained plasma between pulse cycles appears to be produced at a higher frequency. The results impart information about the pulsed-DC driven plasma discharge at low pressure as well as the role energetic ions play on the cathode and elucidate the mechanisms of plasma deposition on the interior tube wall.

The Research on Discharge Tube Structure of Fast-Axial-flow CO 2 Lasers

Modeling of Kinetic and Thermodynamic Processes in a Flowing Exciplex Pumped Alkali Vapor Laser

Modeling of Three-Dimensional Exciplex Pumped Fluid Cs Vapor Laser with Transverse and Longitudinal Gas Flow

Simulation and Comparison of Discharge Cirsuits for Metal Vapor Lasers

Three-Dimensional Kinetic and Fluid Dynamic Modeling and Three Iterative Algorithms for Side-Pumped Alkali Vapor Lasers

Theoretical Investigation on Exciplex Pumped Alkali Vapor Lasers with Sonic-Level Gas Flow

Influence of the Discharge Tube Aperture on the Deexcitation of Lower Level in UV Cu+ Laser

Influence of Cataphoresis on Metal Vapor Distribution in High Repetition Rate Pulsed Discharge Metal Vapor Lasers

A CFD Model for Fast-Axial-flow CO 2 Lasers

The influence of tube-plate electrodes on the laser mode of a fast-transvere- flow C02 laser

The Influence Of Tube-Plate Electrodes On The Laser Mode Of A Fast-Transverse-Flow Co(2) Laser

Research of Discharge Tube Diameter and Discharge Pressure on Fast-axial-flow CO2 Lasers

Progress of Research of Gas Circulation System in the High Power Fast Axial Flow CO2 Laser

Experiment and Simulation on the Discharge Modality of Atmospheric Pressure Plasma Jets in Argon Based on Coaxial Straight Tube and Inverted Tapered Tube

Numerical Modeling of Powder Stream in Extreme High-Speed Linear Laser Material Deposition

Optimization of Discharge Circuit of the Tea Co2 Laser with Two Discharge Channels

Numerical Study on Powder Stream Characteristics of Coaxial Laser Metal Deposition Nozzle

Three-dimensional Modelling of the Flow and Heat Transfer in a Laminar Non-Transferred Arc Plasma Torch

Modeling of Flowing Gas Discharge – Part I

Modeling and experimental comparison of pulsed-DC driven low-pressure plasma discharge in a metal tube

Influence Of Oxidation On Flow Structure In Laser-Oxygen Cutting