Abstract:Fiber Bragg Gratings (FBG) have great significance in the development of high-power fiber laser systems. Fabrication sources, fibers, and fabrication technology would affect the performance of FBGs directly. In this research, a scanning exposure method for fabricating FBGs in different types of photosensitive fibers with a 213nm solid-state laser source was proposed. The Q-switched Nd: YVO4 laser fifth harmonic source was compared with the traditional excimer lasers and the impacts of lengths, center wavelengths, titled angles, and apodization on the reflection and transmission spectra of FBGs were discussed. The scanning fabrication system, which can realize the tilting of phase mask and the adjustment and monitoring of tension, was built according to the characteristics that the output spot diameter of the fabrication source was sub-millimeter. While the high quality of fabrication was guaranteed, FBGs with lengths of 3mm~20mm, center wavelengths shift of 0nm~4.2nm, and tilted angles of 0~21 were obtained, and all the parameters were simultaneously adjusted and controlled, the deepest transmission loss of about -70dB. FBGs fabricated were of good stability and repeatability, especially in hydrogen fibers whose stability was independent of high-temperature annealing (1500C) which was different from the fabrication results of excimer laser sources. Then the unconformity between experimental results and theoretical simulation was discussed and the optimization schemes were proposed. The experimental results and analysis provided a better experimental scheme for UV laser fabricating FBGs and the experimental basis for further optimizing the fabrication technology and further analyzing the microscopic mechanism of optical fiber photosensitivity.

Fabrication of widely tunable SGDBR laser using butt-joint technique

Investigation on Wavelength Switching of Widely Tunable SGDBR Lasers

Tunable Mqw-Dbr Lasers Using Selective Area Growth

Widely Tunable Narrow-Linewidth Laser Based on a Multi-Period-Delayed Feedback Photonic Circuit

Experimental demonstration of a widely tunable two-section DFB laser

Tunable V-Coupled-Cavity Semiconductor Laser Monolithically Integrated with Monitoring Photodiodes Using Deeply Etched Reflective Trenches

Offset Quantum-Well Method for Tunable Distributed Bragg Reflector Lasers and Electro-Absorption Modulated Distributed Feedback Lasers

High power GaSb-based distributed feedback laser with laterally coupled dielectric gratings at 1.95μm

Monolithic tunable lasers for low cost DWDM networks

Ultra-Broadband Optical Filter Based on Step-Chirped Multimode Waveguide Bragg Grating

Wide-Spectrum Tuning and Narrowing of 780 nm Broad-Area Diode Laser with Littrow-Type Transmission Gratings

Slab-Modulated Sidewall Bragg Gratings in Silicon-on-Insulator Ridge Waveguides

Chirped and Phase-Sampled Fiber Bragg Grating for Tunable DBR Fiber Laser.

Widely Wavelength Switchable V-Coupled-Cavity Semiconductor Laser With Similar To 40 Db Side-Mode Suppression Ratio

Widely tunable 780 nm distributed feedback laser based on high-order surface isolation grooves

Fabrication of fiber Bragg gratings with precisely adjustable and controllable parameters based on 213nm solid-state laser

A wavelength-tunable short-cavity DBR laser with active distributed Bragg reflector

Gain-coupled 770 Nm DFB Semiconductor Laser Based on Surface Grating

Study of Cascaded Tunable DFB Semiconductor Laser with Wide Tuning Range and High Single Mode Yield Based on Equivalent Phase Shift Technique

Multi-Wavelength DFB Laser Based on Sidewall Third Order Four Phase-Shifted Sampled Bragg Grating with Uniform Wavelength Spacing

Fabrication of integrated single frequency DBR fiber laser directly on ytterbium doped fiber by femtosecond laser