Abstract:Since the nonlinearity and uncertainties which inherently exist in vehicle system need to be considered in active suspension control law design, this paper proposes a new control strategy for active vehicle suspension systems by using a combined control scheme, i.e., respectively using a genetic algorithm (GA) based self-tuning PID controller and a fuzzy logic controller in two loops. In the control scheme, the PID controller is used to minimize vehicle body vertical acceleration, the fuzzy logic controller is to minimize pitch acceleration and meanwhile to attenuate vehicle body vertical acceleration further by tuning weighting factors. In order to improve the adaptability to the changes of plant parameters, based on the defined objectives, a genetic algorithm is introduced to tune the parameters of PID controller, the scaling factors. the gain values and the membership functions of fuzzy logic controller on-line. Taking a four degree-of-freedom nonlinear vehicle model as example, the proposed control scheme is applied and the simulations are carried out in different road disturbance input conditions. Simulation results show that the present control scheme is very effective in reducing peak values of vehicle body accelerations, especially within the most sensitive frequency range of human response, and in attenuating the excessive dynamic tire load to enhance road holding performance. The stability and adaptability are also showed even when the system is subject to severe road conditions, such as a pothole, an obstacle or a step input. Compared with conventional passive suspensions and the active vehicle suspension systems by using, e.g., linear fuzzy logic control, the combined PID and fuzzy control without parameters self-tuning, the new proposed control system with GA-based self-learning ability can improve vehicle ride comfort performance significantly and offer better system robustness.

Fuzzy pid control for landing gear based on magneto-rheological (MR) Damper

Analysis of the Characteristics of Landing Gear with MR Fluid Damper System

Intelligent Control Based on a Neural Network for Aircraft Landing Gear with a Magnetorheological Damper in Different Landing Scenarios

Research on Anti-Rollover Adaptive Landing Gear Technology Based on Impedance Control

New control logic based on mechanical energy conservation for aircraft landing gear system with magnetorheological dampers

Design, structure analysis and shock control of aircraft landing gear system with MR damper

Control of Magneto-Rheological Damper Based on Fuzzy PID Controller

On Fuzzy Control Strategy of Nonlinear Semi-Active Suspension System

Ga-Based Pid and Fuzzy Logic Control for Active Vehicle Suspension System

LQR-based Ground Resonance Suppression of Helicopter with Adaptive Landing Gear

Adaptive observer-based integral event-triggered antivibration control of a full aircraft active landing gear system with irregular runway excitations

Rotor Vibration Control for Magnetic Suspended High-Speed Flywheel Energy Storage System with Inverse System Method and Extended 2-DOF PID Controller

Design and control of helicopter main reducer vibration isolation platform with magnetorheological dampers

Numerical Simulation of Fuzzy-PID Tension Control System Based on Rotary MRF Damper

Landing efficiency control of a six-degree-of-freedom aircraft model with magnetorheological dampers: Part 1—Modeling

Active Vibration Control of Rotor System by A Magneto-Rheological Fluid Damper

Fuzzy PID control method for damping of electronically controlled air suspension shock absorbers for vehicles

Design and Performance of Directional Rectification Control System in an Aircraft with a Novel Type of Wheel-Ski Landing Gear

Research on the Stability and Bifurcation Characteristics of a Landing Gear Shimming Dynamics System

Adaptive Fuzzy Control for Aircraft Tractor'S Magneto Rheological Semi-Active Suspension

Fuzzy-PID Switch Control on Semi-active Suspensions with MR Damper