Abstract:Piezoelectric energy harvesting is gaining popularity as an eco-friendly solution to harvest energy from tire deformation for tire condition monitoring systems in vehicles. Traditional piezoelectric harvesters, such as cymbal and bridge structures, cannot be used inside tires due to their design limitations. The wider adoption of renewable energy sources into the energy system is increasing rapidly, reflecting a global attraction toward the utilization of sustainable power sources (Aljendy et al. in Int J Power Energy Convers 12(4): 314–337, 2021; Yesner et al. in Evaluation of a novel piezoelectric bridge transducer. In: 2017 Joint IEEE International Symposium on the Applications of Ferroelectric (ISAF)/International Workshop on Acoustic Transduction Materials and Devices (IWATMD)/Piezoresponse Force Microscopy (PFM). IEEE, 2017). The growing interest in capturing energy from tire deformation for Tire Pressure Monitoring Systems (TPMS) aligns with this trend, providing a promising and self-sustaining alternative to traditional battery-powered systems. This study presents a novel one-end cap tire strain piezoelectric energy harvester (TSPEH) that can be used efficiently and reliably inside a tire. The interaction between the tire and energy harvester was analyzed using a decoupled modeling approach, which showed that stress concentration occurred along the edge of the end cap. The TSPEH generated a maximum voltage of 768 V under 2 MPa of load, resulting in an energy output of 32.645 J/rev under 1 MPa. The computational findings of this study were consistent with previous experimental investigations, confirming the reliability of the numerical simulations. The results suggest that the one-end cap structure can be an effective energy harvester inside vehicle tires, providing a valuable solution for utilizing one-end cap structures in high-deformation environments such as vehicle tires.

Battery-less Piezoceramics Mode Energy Harvesting for Automobile TPMS

Batteryless Tire Pressure Real-Time Monitoring System Driven by an Ultralow Frequency Piezoelectric Rotational Energy Harvester.

A 125 kHz Power Recovery Circuit Design for Battery-less TPMS SoC

A High-Efficiency Piezoelectric Energy Harvesting and Management Circuit Based on Full-Bridge Rectification

The Optimal Design of a Piezoelectric Energy Harvester for Smart Pavements

A Nail-Size Piezoelectric Energy Harvesting System Integrating a MEMS Transducer and a CMOS SSHI Circuit

Wireless power transfer and a Dual-Slope ADC design for Battery-less TPMS

A 125khz Low Frequency Power Recovery Circuit for Battery-Less Tpms Soc

Mechanical Energy Harvesting from Road Pavements under Vehicular Load Using Embedded Piezoelectric Elements

Key Module Design Of A Battery-Less Tpms On Chip

Simulated and measured piezoelectric energy harvesting of dynamic load in tires

Forced‐Vibration Nonlinear Piezoelectric Energy Harvesters

A Tire Pressure Monitoring System Based on Mems Sensor

Energy Harvesting in Tire: State-of-the-Art and Challenges

The future of tire energy: a novel one-end cap structure for sustainable energy harvesting

A Passive Design Scheme to Increase the Rectified Power of Piezoelectric Energy Harvesters

A Low Power Consumption Tire Pressure Monitoring System

All Switched-Capacitor Realized Piezoresistive Pressure Sensor Interface Chip for Automotive TPMS.

Piezoelectric MEMS Energy Harvester for Low-Power Applications

Design and Test of a Spoke-like Piezoelectric Energy Harvester

A Low-Power 433mhz Transmitter for Battery-Less Tire Pressure Monitoring System.