Abstract:At present, the positioning control of the hydraulic support pushing systems in fully mechanized mining faces uses an electrohydraulic directional valve as the control component, while the current research mainly focuses on servo valves, proportional valves, high−speed on−off valves, and electromagnetic directional valves. At present, the positioning control for electrohydraulic directional valves is only a simple logical control. Therefore, in order to improve the positioning control accuracy of the hydraulic support pushing system, a predictive positioning control strategy based on iterative learning was designed. Firstly, mathematical modeling of the hydraulic support pulling process was carried out, and its state−space equation was established. Secondly, an iterative learning controller with a state observer was designed, in which the iterative learning method was used to predict the control advance in the positioning process, and the state observer was used to estimate the parameters that could not be measured by the system, so as to improve the control accuracy in the broaching process. Then, a SimulationX–Simulink joint simulation model of the position control system of a multi−cylinder pulling hydraulic support was built, and the designed iterative learning controller was compared with the BP neural network controller. Finally, a test platform for the hydraulic support pushing system was built, and the proposed control strategy was experimentally verified. The research results show that the iterative learning control strategy proposed for the electrohydraulic directional valve not only simplifies the design process of the controller but also has higher positioning control accuracy. The single−cylinder positioning control accuracy can be controlled within 10 mm, and the multi−cylinder coordinated positioning control accuracy can be controlled within 15 mm, which meets the accuracy requirements of the site.

The Intelligent Learning Control On Slide Position Of Mechanical Crank Press

Non-cylinder Holes Precision Machining by Giant Magnetostrictive Components with Sliding Mode Control

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Simultaneous Control of Motion and Maximized Stiffness for an Electro-Pneumatic Clutch Actuator Based on Pressure Observers

Hybrid Position/Force Control for Dual-Machine Drilling and Riveting System

High-performance Motion Control of the Hydraulic Press Based on an Extended Fuzzy Disturbance Observer

Implementation of sliding mode control of giant magnetostrictive smart component by neural network

Expert-PID Synchronization Control of Thrust Hydraulic System

Preliminary Exploration on Control Theory of Ultraprecision Stage with Large Travel

Research and Application of Intelligent Control Method of Small Type Loader Actuator

Control of a 3D Piezo-Actuating Table by Using an Adaptive Sliding-Mode Controller for a Drilling Process.

Micro-Drilling Process Control by Using Adaptive Sliding Controller

Experimental Study on a Hybrid-Driven Servo Press Using Iterative Learning Control

Research on Positioning Control Strategy for a Hydraulic Support Pushing System Based on Iterative Learning

Simulation of Iterative Learning Control Strategy in Powder Metallurgic Forming Machine

Learning-Enhanced PI and Fuzzy-Sliding-Mode Tracking of a Piezo-Actuated System

Piezo-Actuated Micro-Drilling Process Control by Using an Adaptive Sliding Controller with Fuzzy Compensation

Thermo-Mechanical Coupling Analysis of the Actuating Mechanism in a High Speed Press

Gain-Scheduled Sliding-Mode-Type Iterative Learning Control Design for Mechanical Systems

Semiclosed Loop Based on Predictive Current Control for SPMSM Drives During Servo Stamping

Multivariable Iterative Learning Control Design for Precision Control of Flexible Feed Drives