Abstract:In this paper, a servo motor operated rotary directional control valve is proposed, and a systematic analysis of steady flow torques in this valve is provided by theoretical calculation, CFD simulation and experimental test. In the analysis, spool rotation angle corresponding to the maximum orifice opening is tagged as 0 degrees. Over a complete change cycle of the orifice, the range of spool rotation angle is symmetric about 0 degrees. The results show that the direction of steady flow torques in this valve is always the direction of orifice closing. The steady flow torques serve as resistances to the spool rotation when the orifice opening increases, while impetuses to the spool rotation when the orifice opening decreases. At a certain pressure drop or flow rate, steady flow torques are approximately equal and opposite when at spool rotation angles which are symmetric about 0 degrees. When the spool rotates from 0 degrees, at a certain pressure drop, their values increase first then decrease with the spool rotation and reach their maximum values at an angle corresponding to about 1/2 of the maximum orifice opening, and at a certain flow rate, their values increase with the spool rotation. The steady flow torques in this valve are the sums of those in the meter-in and meter-out valve chambers. At a certain spool rotation angle, steady flow torques in the meter-in and meter-out valve chambers are approximately proportional to the pressure drop and the second power of the flow rate through the orifice. Theoretical calculation and CFD simulation can be validated by the experimental test. The proposed calculation formulas can predict the steady flow torques in the rotary directional control valve correctly. (C) 2015 Elsevier Ltd. All rights reserved.

Development of pneumatic measurement and device for servo valve orifice edge axial dimension error

Visualization and Influence Factors of Erosion at the Working Edge of a Hydraulic Servo Spool Valve

Identification of Characteristic Parameters and Structure Parameters in Pneumatic Servo Control

Steady Flow Torques in a Servo Motor Operated Rotary Directional Control Valve

Modeling of a pneumatic system for high-accuracy position control

Research on Stability and Minimum Orifice Area of Hydraulic Servo Position Control System

Development of In-out-burst Pneumatic On/off Valve

The Simulation Study of a New-Type Frictionless Pneumatic Cylinder

Modeling and characteristics investigation on a new pneumatic proportional pressure valve

Modelling And High-Precision Constant Pressure Control Of The Pneumatic Suspension System

Research and Development of A Test System for the Dynamic Performance Testing of Pneumatic Solenoid Valves

Design and Simulation of a High Pressure Proportional Pneumatic Pressure Reducing Valve

Design and Characteristics Analysis of a High Precision Pneumatic Proportional Pressure Valve

An indirect flow measurement based high-precision slide valve grinding mechanism for hydraulic servo valve

Experimental and Numerical Investigation of Flow Forces in a Seat Valve Using a Damping Sleeve with Orifices

Static and Dynamic Performance Improvement of a Hydraulic Feedback Valve for Load Control by Introducing Force Feedback and Compensation Orifice

Reduction of Steady Flow Torques in a Single-Stage Rotary Servo Valve

Effects of Orifice on Pressure Difference in Pilot-Control Globe Valve by Experimental and Numerical Methods

A Dead-Band Model and Its Online Detection for the Pilot Stage of A Two-Stage Directional Flow Control Valve

Development of electrical runout online measurement system based on eddy current technique and laser triangulation

Computational fluid dynamics analysis on orifice structure inside valve core of pilot-control angle globe valve