Abstract:A comprehensive comparison between a direct acting and an indirect acting piezoelectric injector has been carried out both at the hydraulic rig and at the dynamometer cell. The working principle of these injector typologies is illustrated, and their hydraulic performance has been analyzed and discussed on the basis of experimental data collected at a hydraulic test rig. The injector characteristics, nozzle opening and closure delays, injector leakages, injected flow-rate profiles, injector-to-injector variability in the injected mass, injected volume fluctuations with the dwell time (DT), and minimum DT for fusion-free multiple injections have been compared in order to evaluate the impact of the injector driving system on the injection apparatus performance. The direct acting and indirect acting piezoelectric injectors have been installed on a Euro 5 diesel engine, which has been tested at a dynamometer cell. Optimized double and triple injection strategies have been considered at some representative key points of the New European Driving Cycle (NEDC). Experimental data on engine-out emissions, brake-specific fuel consumption (bsfc), and combustion noise (CN) are presented and discussed with the support of a three-zone diesel combustion diagnostic model. The research has focused on the cause-and-effect relationships between hydraulic performance of the injectors and results of the engine tests. The main objective is to assess the possible differences in engine performance between the direct acting and indirect acting piezoelectric injector setups and to provide a clear evaluation of the benefits of the direct acting technology. In particular, the potential of the boot injection in direct acting injectors is assessed by comparison with engine results, which refer to efficient multiple injection schedules implemented on indirect acting piezoelectric injectors.

Development of an Adaptive Driving Module for Piezo Actuated Diesel Fuel Injector

Driving Control Method of Piezo Actuator Diesel Fuel Injector

Research and development of an electronically controlled pump-pipe valve-injector fuel injection system

Feedback Control of Fuel Injection Based on Online Valve Closure Point Detection

Research and Development on a Novel Driving Module for Injector High-Speed Solenoid Valve of High-Pressure Common Rail System

Development of a Novel Dual-Coil Fuel Injector for Direct-Injection Spark Ignition Engines

Development of A Piezoelectric-Actuated Drop-On-Demand Droplet Generator Using Adaptive Wavelet Neural Network Control Scheme

Integrated Direct/Indirect Adaptive Robust Control for Electrical Driven Injection Machine Mold Closing with Accurate Parameter Estimations.

Fuel injection rate variation of a piezoelectric injector according to the charge current patterns

Injection control algorithm for an electronic unit-pump

Study of the injection control valve in a new electronic diesel fuel system

Modelling and identification of a piezoelectrically driven fuel injection control valve

Adoptive Control of Injector for Polymer Electrolyte Membrane Fuel Cell Hydrogen Feeding System

Direct Versus Indirect Acting Piezoelectric CR Injectors: Comparison of Hydraulic Performance, Pollutant Emissions, Combustion Noise, and Fuel Consumption

A Fuel Injection Control Soc For Diesel Engine Management System

A Kind of Common-Rail Electronical Controlled Diesel Fuel Injection System

Common rail injection system on-line parameter calibration for precise injection quantity control

MODEL-BASED OPTIMIZATION AND PRESSURE FLUCTUATION CONTROL OF PRESSURE RESERVOIR IN ELECTRICALLY CONTROLLED FUEL INJECTION SYSTEM FOR SINGLE CYLINDER DIESEL ENGINE

An Innovative Rail Pressure Sensor Signal Processing Algorithm to Determine the Start of Injection and End of Injection of Diesel Engines With Common Rail Injection Systems.

Application of Narrow Cone Angle Injectors to Achieve Advanced Compression Ignition on a Mass-Production Diesel Engine - Control Strategy and Engine Performance Evaluation

Common rail injection system iterative learning control based parameter calibration for accurate fuel injection quantity control