Abstract:A comprehensive comparison between a direct acting and an indirect acting piezoelectric injector has been carried out both at the hydraulic rig and at the dynamometer cell. The working principle of these injector typologies is illustrated, and their hydraulic performance has been analyzed and discussed on the basis of experimental data collected at a hydraulic test rig. The injector characteristics, nozzle opening and closure delays, injector leakages, injected flow-rate profiles, injector-to-injector variability in the injected mass, injected volume fluctuations with the dwell time (DT), and minimum DT for fusion-free multiple injections have been compared in order to evaluate the impact of the injector driving system on the injection apparatus performance. The direct acting and indirect acting piezoelectric injectors have been installed on a Euro 5 diesel engine, which has been tested at a dynamometer cell. Optimized double and triple injection strategies have been considered at some representative key points of the New European Driving Cycle (NEDC). Experimental data on engine-out emissions, brake-specific fuel consumption (bsfc), and combustion noise (CN) are presented and discussed with the support of a three-zone diesel combustion diagnostic model. The research has focused on the cause-and-effect relationships between hydraulic performance of the injectors and results of the engine tests. The main objective is to assess the possible differences in engine performance between the direct acting and indirect acting piezoelectric injector setups and to provide a clear evaluation of the benefits of the direct acting technology. In particular, the potential of the boot injection in direct acting injectors is assessed by comparison with engine results, which refer to efficient multiple injection schedules implemented on indirect acting piezoelectric injectors.

Driving Control Method of Piezo Actuator Diesel Fuel Injector

Development of an Adaptive Driving Module for Piezo Actuated Diesel Fuel Injector

Fuel injection rate variation of a piezoelectric injector according to the charge current patterns

Research and development of an electronically controlled pump-pipe valve-injector fuel injection system

Feedback Control of Fuel Injection Based on Online Valve Closure Point Detection

Modelling and identification of a piezoelectrically driven fuel injection control valve

Study of the injection control valve in a new electronic diesel fuel system

A Kind of Common-Rail Electronical Controlled Diesel Fuel Injection System

MODEL-BASED OPTIMIZATION AND PRESSURE FLUCTUATION CONTROL OF PRESSURE RESERVOIR IN ELECTRICALLY CONTROLLED FUEL INJECTION SYSTEM FOR SINGLE CYLINDER DIESEL ENGINE

Direct Versus Indirect Acting Piezoelectric CR Injectors: Comparison of Hydraulic Performance, Pollutant Emissions, Combustion Noise, and Fuel Consumption

Injection control algorithm for an electronic unit-pump

Design of Control Circuits of Electronic Fuel Injection for Diesel Spray Characteristics

A Fuel Injection Control Soc For Diesel Engine Management System

A Multi-Mode Self-Centering Piezo Actuator: Design, Analysis and Its Application in Full-Stroke Microscopic Imaging

Common rail injection system iterative learning control based parameter calibration for accurate fuel injection quantity control

Optimization of Injection Solenoid Valve Drive Logic for an Electronic Diesel Engine

Pulsed solenoid valve and its intelligent driver in an electronic diesel fuel injection system

Injection of Viscous Micro-Droplet via Nozzle-Driven Piezoelectric Micro-Jet and Its Performance Control Method

Optimization of the Driving Waveform of a Piezoelectric Inkjet Printhead Based on a System Dynamics Model

Research on the Control Strategy of Fuel Injection System with Electronic Unit Pump

Investigation and Comparison of Two Fuzzy PID Control Methods on the Injector Pressure of GD-1 High Pressure Common Rail Diesel Engines