Abstract:Regional sensible and latent heat fluxes are the key physical parameters of the meteorological, hydrological and ecological models. However it is very difficult to obtain these fluxes from conventional ground measurement. Using satellite remotely sensed data to retrieve these fluxes supplies one possible way to solve this problem. However, the gradient measurement is needed when calculating the fluxes are calculated, while the measurements from only one layer can be obtained from satellite. To solve this problem, many studies have been carried out. There are two main ways that can be seen: the physical model and empirical model. The physical models have two directions: the gradient model and the thermal inertia method. Gradient models combine the satellite remotely sensed data with the ground measurements, and use the difference of surface temperature and air temperature at reference height to calculate sensible heat flux. The latent heat flux is obtained as the residual. The thermal inertia method uses the response of soil to the absorption of solar radiation to calculate the sensible and latent heat flux. The empirical method calculates empirical regression between the measurements of the fluxes and the satellite remotely sensed data, and then extends this relationship to calculate the fluxes. Here the daily-average fluxes are often used. Four gradient models are reviewed, including one one-source model and three two-source models. When use the one-source model is used for to partly vegetation-covered surface, the difference of the air dynamic temperature and the thermal radioactive temperature hinds it usage. Two-source models can solve this problem. However, all the gradient models are sensitive to the error of the difference between the satellite retrieved surface temperature and the measurements of the air temperature. Another shortcoming of the gradient model is that they need to interpolate ground measurements, such as the air temperature and wind speed. These interpolations always are of low quality with unacceptable errors. The thermal inertia method calculates sensible and latent heat fluxes only using the satellite remotely sensed data, which will have a wider usage in the near future. However, up to today, this method only succeeded in the bare soil surface. More attention should be paid to it in the future. At last, the methods used to evaluate the accuracy of the retrieval of sensible and latent heat fluxes are reviewed.

Coupling of the Harmonic Analysis Method and Two-Source Energy Model to Estimate Soil Heat Flux and Evapotranspiration

Numerical Simulation and Analysis on the Heat Transfer of the Vertical Ground Heat Exchanger in Hydrous Soil

Application of a two source energy balance model coupled with satellite based soil moisture and thermal infrared data

Intercomparison of Three Two-Source Energy Balance Models for Partitioning Evaporation and Transpiration in Semiarid Climates

Application of Harmonic Analysis to Estimate Soil Heat Flux Using Remotely Measured Surface Temperature

A Simple Temperature Domain Two‐source Model for Estimating Agricultural Field Surface Energy Fluxes from Landsat Images

Evaluating Soil Resistance Formulations in Thermal‐Based Two‐Source Energy Balance (TSEB) Model: Implications for Heterogeneous Semiarid and Arid Regions

Water and Heat Transport in Hilly Red Soil of Southern China: II. Modeling and Simulation.

Ground heat flux determination based on near-surface soil hydro-thermodynamics

A hybrid dual-source scheme and trapezoid framework-based evapotranspiration model (HTEM) using satellite images: Algorithm and model test

Water Flux Characterization Through Hydraulic Head and Temperature Data Assimilation: Numerical Modeling and Sandbox Experiments

Generation of Spatio-Temporally Continuous Evapotranspiration and Its Components by Coupling a Two-Source Energy Balance Model and a Deep Neural Network over the Heihe River Basin

Two Improvements of an Operational Two-Layer Model for Terrestrial Surface Heat Flux Retrieval

USING SATELLITE REMOTELY SENSED DATA TO RETRIEVE SENSIBLE AND LATENT HEAT FLUXES: A REVIEW

Comparison of three dual-source remote sensing evapotranspiration models during the MUSOEXE-12 campaign: Revisit of model physics: Two-source remote sensing ET model comparision

Integrating Temperature Gradient-Based 3T and Resistance-Based Models for Simulating Evapotranspiration and Its Components

A Temperature Prediction-Correction Method for Estimating Surface Soil Heat Flux from Soil Temperature and Moisture Data

A Temperature-Domain SEBAL Model Based on a Wind Speed-Independent Theoretical Trapezoidal Space Between Fractional Vegetation Coverage and Land Surface Temperature

Methods comparison of soil heat flux in remote sensing model to estimate evapotranspiration

Global estimation of evapotranspiration using a leaf area index-based surface energy and water balance model

An Approach for Surface Fluxes Estimations over Heterogeneous Terrain by Means of Remotely Sensed Data and Dem