Abstract:According to the characteristics of energy acquisition applied to tags, a monitoring circuit was added between the energy acquisition module and the tag module, and the cooperative working strategy of energy acquisition and tags was put forward based on the setting of high and low thresholds. The low threshold selection principle is to ensure that the energy storage of the energy storage module can ensure the one-time broadcasting of the tag and prevent the tag from entering the power down state to the maximum extent. The optimal value of energy storage capacitance, minimum and optimal radio frequency (RF) input power in the environment were deduced by starting from the broadcast interval and power required in the tag design goal according to the amount of energy that can be collected in the environment and the change of energy consumption required by the tag in different states. A tag based on RF acquisition was designed by using P2110B and CC2640R2F chip for verification. Test results show that the energy acquisition tag designed by this method can realize the cooperative work of energy acquisition module and tag module. The tag can carry out continuous “sleep and broadcast” cycle when the RF input power is greater than the optimal value. It can effectively prevent the label from falling into “energy deadlock”, and can adaptively switch in different working states.

Analysis, design and implementation of semi-passive Gen2 tag

Analysis and Design of Power Efficient Semi-Passive Rfid Tag

Design method of electronic tag based on radio frequency energy acquisition

Design and Implementation of an Ultra-Low Power Passive UHF RFID Tag

A semi-passive UHF RFID tag with on-chip temperature sensor

A Two-Stage Wake-Up Circuit for Semi-Passive RFID Tag

Low Power Design of RFID Tags

Low-Cost Low-Power Uhf Rfid Tag With On-Chip Antenna

Design of a low-cost low-power baseband-processor for UHF RFID tag with asynchronous design technique

Design and Implementation of a High Sensitivity Fully Integrated Passive UHF RFID Tag

High-Efficiency Differential RF Front-End for a Gen2 RFID Tag.

A Low Voltage, Low Power RF/Analog Front-End Circuit for Passive UHF RFID Tags

A Low Power,Large Dynamic Range 915mhz Passive RFID Tag

Power Management And Clock Generator For A Novel Passive Uwb Tag

High Data Capacity Chipless RFID Tag Based on Time Domain Scattering Modulation

An Ultra Low-Voltage, Low-Power Baseband-Processor for UHF RFID Tag

A high-efficient energy harvest chain for ultra-low power passive UHF RFID tags

Analysis and Design of a Low-Cost RFID Tag Analog Front-End

A Two-stage Wakeup Unit for Temperature Logger Tag

An Active Tag Using Carrier Recovery Circuit for EPC Gen2 Passive UHF RFID Systems.

Low Power Design of UHF RFID Tag Baseband Processor