Study on the High-temperature Properties of High-titania Slags produced with Cr-bearing Vanadia-titania Magnetite Smelting in Blast Furnace
Hanlin Song,Jinpeng Zhang,Gongjin Cheng,Songtao Yang,Xiangxin Xue
DOI: https://doi.org/10.1016/j.surfin.2020.100767
IF: 6.2
2020-12-01
Surfaces and Interfaces
Abstract:The high-temperature metallurgical property of high-titania slag is one of the most significant indicators to measure the production status of Cr-bearing vanadia-titania magnetite blast furnace (CVTM-BF). Due to the continuous high temperature in the furnace, titania is over-reduced to titanium carbonitride with a high melting point (over 3000°C), which causes the viscosity of the slag to be too high to separate the molten iron and molten slag well. However, a high proportion of N2 in the air blasted into the furnace participates in the generation of TiN, and the large required air volume causes a high coke ratio and excessively high furnace temperature, which is not conducive to suppressing the over-reduction of titania. Here we show that TiN was significantly reduced and the metallurgical properties of high-titania slag were improved by injecting abandoned basic oxygen furnace gas (ABOFG), which is a kind of by-product gas containing CO, CO2, lower N2 and high physical heat. The experimental results demonstrated that the ABOFG was likely to function in suppressing TiN from 2.46% to 1.06%, dropping the melting temperature down from 1478.8°C to 1290.3°C, pushing the slag-iron interface tension from 0.641 N/m to 0.882 N/m as well as bring the viscosity down from 0.353 Pa⋅s to 0.341 Pa⋅s. Overall, ABOFG as a kind of endothermic atmosphere compared to O2-enriched air is beneficial to restrain the over-deduction of titania to TiN upon the slag-coke interface with lower N2. It also helps CVTM-BF to be recovered from the continued deterioration as soon as possible.
chemistry, physical,physics, applied, condensed matter,materials science, coatings & films