Abstract:The oxygen/silver system exhibits unique catalytic behavior for several large-scale oxidation (and partial oxidation) industrial processes. In spite of its importance, very little is known on the microscopic level concerning the atomic geometry and chemical nature of the various O species that form. Using density-functional theory within the generalized gradient approximation, the interaction between atomic oxygen and the Ag(111) surface is investigated. We consider. for a wide range of coverages. on-surface adsorption as well as surface-substitutional adsorption. The on-surface fcc-hollow site is energetically preferred for the whole coverage range considered. A significant repulsive interaction between adatoms is identified, and on-surface adsorption becomes energetically unstable for coverages greater than about 0.5 monolayer (ML) with respect to gas-phase O-2 The notable repulsion even at these lower coverages causes O to adsorb in subsurface sites for coverages greater than about 0.25 ML. The O-Ag interaction results in the formation of bonding and antibonding states between Ag 4d and O 2p orbitals where the antibonding states are largely occupied, explaining the found relatively weak adsorption energy. Surface-substitutional adsorption initially exhibits a repulsive interaction between O atoms, but for higher coverages switches to attractive, towards a (root3 x root3)R30degrees structure. Scanning tunneling microscopy simulations for this latter structure show good agreement with those obtained from experiment after high-temperature and high-O-2-gas-pressure treatments. We also discuss the effect of strain and the found marked dependence of the adsorption energy on it, which is different for different kinds of sites.

First-Principles Study of Carbon Monoxide Oxidation on Ag(111) in Presence of Subsurface Oxygen and Stepped Ag(221)

Sub-surface Oxygen and Surface Oxide Formation at Ag(111): A Density-functional Theory Investigation

The Effect of Water on the CO Oxidation on Ag(111) and Au(111) Surfaces: A First-Principle Study

A First-Principle Study of Synergized O2 Activation and CO Oxidation by Ag Nanoparticles on TiO2(101) Support.

Experimental and theoretical study of oxygen adsorption structures on Ag(111)

Oxygen Adsorption on Ag(111): A Density-Functional Theory Investigation

Density-Functional Theory Calculations for the Carbon-Monoxide and Hydrogen Co-Adsorbed on Ni(111) Surface

Theoretical Studies of CO Oxidation with Lattice Oxygen on Co3O4 Surfaces

Oxidation of Platinum Surfaces and Reaction with Carbon Monoxide

Co Adsorption on Pt (111) and Pd (111) Surfaces: A First-Principles Based Lattice Gas Monte-Carlo Study

Role of Subsurface Oxygen on Cu Surfaces for CO2 Electrochemical Reduction

Dissociative Adsorption of O2 on Clean and CO-Precovered Pt Surfaces

Initial Subsurface Incorporation of Oxygen into Ru(0001): A Density Functional Theory Study

Density Functional Theory Study of CO Catalytic Oxidation on Pt(111) and Pt(3)Ni(111) Surfaces

Oxidation of Carbon Monoxide on Rh(111): A Density Functional Theory Study

Carbon monoxide adsorption and dissociation on Mn-decorated Rh(111) and Rh(553) surfaces: A first-principles study

CO Oxidation at the Perimeters of an FeO/Pt(111) Interface and How Water Promotes the Activity: a First-Principles Study.

Dissociative Adsorption of O2 on Ag3Au(111) Surface: A Density Functional Theory Study

High-Pressure Co Oxidation On Pt(111) Monitored With Infrared-Visible Sum Frequency Generation (Sfg)

CO adsorption and oxidation on oxygen precovered Cu(110) at 150 K: reactivity of two types of adsorbed atomic oxygen determined by scanning tunneling microscopy

CO adsorption on a Pt(111) surface partially covered with FeO x nanostructures