Research on pore structure of coal char during pyrolysis in fluidized bed
Yiqun Huang,Man Zhang,Hairui Yang,Junfu Lyu,Qing Liu
2017-01-01
Abstract:The physical structure of char has a significant influence on the subsequent char reaction and ash formation. Understanding of the evolution of char structure after pyrolysis or devolatilization is crucially important to the development of advanced coal combustion technology. In the present study, the effects of particle size and pyrolysis temperature on pore structure of a bituminous coal in a fluidized bed were examined. The swelling ratio, external structure and pore structure of char are different for coals with different sizes. Volatile matter may diffuse by bubble mechanism in small coal particle and by original pore in large coal particle. INTRODUCTION Coal combustion is one of the most important applications in fluidized bed technologies. In circulating fluidized bed (CFB), coal combustion generally involves several steps: the devolatilization of organic materials leaving char behind, homogeneous reactions of volatile matter with the reactant gases and heterogeneous reactions of the resulting char with the reactant gases. After devolatilization, the physical structure of a char changes significantly and becomes highly heterogeneous, which has a significant influence on the subsequent char reaction and ash formation. So, understanding of the evolution of coal particle structure during pyrolysis or devolatilization is crucially important to the development of advanced coal combustion technology. It is shown that the porous structure of coal char is strongly dependent on coal rank based on previous studies. Low grade coal would form more solid char with low porosity (Bailey, 1990). Middle grade coal would form more cenospheric char with high porosity and swelling ratio (Benfell, 2001). And high grade coal would usually form more solid char with low porosity and thick wall (Alvarez, 1997). The difference in the morphology of a char from different rank coal may be attributed to the difference in their thermoplasticity and the extent to which a coal is devolatilized (Yu, 2007). Many bituminous coals have been known to undergo swelling during pyrolysis, and direct observations of swelling behavior of individual coal particles have been completed with video cameras (Gao, 1997). Most bituminous coals exhibit a plastic transformation during devolatilization, where a portion of the coal mass becomes liquid, softening and deforming while undergoing devolatilization. And it is found that coal properties and experimental conditions, including atmosphere, heating rate, pressure and coal particle size, have important effects on pore structure of coal char. As the temperature increases, sub-bituminous coals produce less amount of heavy-density and thick-walled chars (Bailey, 1990). A decrease of the char micro-porosity at a higher temperature at 1770K was measured compared to chars from the same coal prepared at 1270K (Cai HY, 1998). Gale et al. (1995) compared their results to others and found that the overall porosity and swelling ratio of char increased with increasing of the heating rate up to 103K/s, then levelled off. Wen et al. (2014) found that the greater the particle size, the less was the swelling ratio of char at the same pyrolysis condition. However, due to different conditions used in experimental studies, the evolution of pore structure of coal char during pyrolysis is such a complicated process that conflicting results may sometimes be obtained. Thus, the knowledge of the evolution of pore structure of coal char is far from enough, though significant efforts have been made to extend knowledge in recent years. Besides, most coal pyrolysis experiments were carried out in a drop tube furnace, where combustion condition was different from fluidized bed combustion. This paper provides an experimental study of effects of particle size and pyrolysis temperature on pore structure of char during pyrolysis of bituminous coal in a fluidized bed. Pyrolysis of bituminous coal with different particle size was carried out at different pyrolysis temperatures in a lab-scale fluidized bed test rig. The particle size, external structure and porous structure of resultant char were carefully analyzed. Finally, the different diffusion ways of volatile matter in the particles with different size were analyzed also.