Technical Parameters of Dibenzothiophene Biodesulfurization in an Air-Lift Bioreactor

张文娟,李资庭,张英,陈晗,李伟
DOI: https://doi.org/10.3321/j.issn:1003-9015.2008.03.022
2008-01-01
Abstract:Using hexadecane as model oil and dibenzothiophene (DBT) as model sulphocompound, the simulating study on oil biodesulfurization was conducted by the biodesulfurization of DBT in an airlift bioreactor with Microbacterium sp. ZD-M2, which has the capability of converting DBT into 2-hydroxybiphenyl(2-HBP). The experimental results show that, for the used airlift bioreactor, the most suitable empty column gas velocity is 7.07 cm·s-1, and under different resting cell concentrations, the highest specific desulfurization rate of the airlift bioreactor is 0.283 (mmol 2-HBP)·(kg DCW·min)-1, which is about 2.26 times of the highest specific desulfurization rate that the shake flasks can have. The effects of different growth mediums and DBT and resting cell concentration on the biodesulfurization were studied, and it was found that for resting cells of ZD-M2, the desulfurization in non-growth medium is as efficient as in the growth medium, and both the high DBT and cell concentration would inhibit the desulfurization activity. However, the airlift bioreactor could alleviate this negative effect to a certain extent by enhancing its mass transfer rate in contrast to shake flasks or stirred tank reactor. It was also found that, for the airlift bioreactor, the biodesulfurization of DBT in hexadecane by ZD-M2 takes place on the oil-aqueous interface, and when the gas velocity is too high, the air-liquid interface area decreases, which cause the decreases of mass transfer rate of oxygen and the effect of desulfurization.
What problem does this paper attempt to address?