Membrane fouling related to microbiological characteristics in membrane bioreactor

Tong ZHU,Yuan-hua XIE,Jin HAN,Jing JIANG,Jian-feng LIU,Tsutomu NOZAKI
DOI: https://doi.org/10.3969/j.issn.1005-9954.2008.11.011
2008-01-01
Abstract:The submerged flat membrane bioreactor with Anoxic/Oxic (A/O) process was used to treat urban domestic wastewater. The relationship between microbiological characteristics and membrane fouling was investigated by the molecular biological methods of PCR-DGGE and FISH. The results show that when MLSS is 1.10 × 104mg/L, the size of sludge flocs that occupied the largest volume fraction is 47.75μm, and the volume fraction of micro particles smaller than 2μm is 1.01%. The content of zoogloea is maximum value 36.5% in bacteria, and the operating pressure of membrane module decreases to the minimum value 4.5 kPa. When MLSS is 2.05 × 104 mg/L, the size of sludge floes that occupied the largest volume fraction is 24.54μm, the volume fraction of micro particles smaller than 2μm is 2.07%, the content of zoogloea decreases to the minimum value 15.5%, and the operating pressure of membrane module increases to 17 kPa. The results indicate that if the active sludge has better bacteria diversity and higher content of zoogloea, the sludge flocs is of bigger size and with less micro particles which could easily jam the holes of membrane and decrease the operating pressure of membrane module. The study shows that the microbiological characteristic of membrane bioreactor is one of the most important factors of membrane fouling.
What problem does this paper attempt to address?