Abstract:Understanding the high-temperature evaporation process of atomized wastewater droplets is a prerequisite for designing an efficient spray evaporation wastewater treatment facility. However, some dynamic characteristics during the evaporation of high-temperature wastewater droplets have not yet been fully understood. Here, the convective evaporation process of desulfurization wastewater droplet in high-temperature gas, which is commonly encountered in the spray drying technology to treat desulfurization wastewater in power plants, was investigated adopting the single droplet drying (SDD) device. In-situ droplet information including the morphology, radius, temperature, and mass was recorded. The influence of bulk temperature and the initial concentration of dissolved solids on evaporation kinetics was studied. To explore the development of resistances during the evaporation process as well as develop a reliable and flexible droplet evaporation model useful for CFD simulations, experimental results were correlated with a modified Reaction Engineering Approach (REA) framework, which revised the previous linear shrinkage model into a hybrid model to illustrate the droplet/particle deformation considering the possible inflation phenomenon at elevated temperatures. The results show that crust formation and internal bubble nucleation induced by wastewater components contributed to unique evaporation features including decreasing evaporation rate and inflation of semi-dried particles. Increasing bulk temperature enhanced the evaporation rate and the degree of inflation. Finally, the rapid and accurate prediction of the modified REA model elucidated its effectiveness to illustrate the whole evaporation and drying process.

Study on Evaporation Characteristics of Flue Gas Purification Technology with Multi-Spouted Bed in Gas-Liquid Main Reaction Zone

NUMERICAL SIMULATION AND EXPERIMENTAL STUDY ON EVAPORATION CHARACTERISTICS IN MULTI-SPOUTED BED

Calculation and Analysis on Evaporation and Mixing Characteristics of Droplets in High Temperature Flue

Desulfurization characteristics of flue gas purification technology with multi-spouted bed in gas-particle main reaction zone

Experimental Study of the Removal of Fine Particulate Matter and Moisture from Flue Gas

Simulation on spray evaporation processes in Multi-spout bed by modified impinging wall method

Flue gas-water direct-contact heat transfer performances

Numerical Investigation on the Evaporation Performance of Desulfurization Wastewater in a Spray Drying Tower without Deflectors

Study on Parameter Optimization of Desulfurized Wet Flue Gas in Spray Condensation Process

Modeling on circulating fluidized bed flue gas desulfurization

Study on Process of SO2 Removal in Flue Gas by White Lime Slurry Atomization in Riser

Study on Spray Evaporation Treatment of Desulfurization Wastewater

Evaporation Characteristics of a Single Desulfurization Wastewater Droplet in High-temperature Gas

Analysis of Main Influencing Factors of the Wastewater Evaporation in Flue Duct

Heat transfer performance of direct-contact flue-gas condensation heat exchanger

Study on Spray Condensation Performance of Desulfurization Wet Flue Gas

Evaluation of droplet evaporation characteristics and its influencing factors in high-temperature gaseous environment

Evaporation Investigation of Single Droplet in High Temperature Fuel Gas

Study on the evaporation performance of concentrated desulfurization wastewater and its products analysis

Dryout Phenomena in a Three‐phase Fixed‐bed Reactor

STUDY ON HEAT TRANSFER CHARACTERISTICS OF FLUE GAS CONDENSATION IN NARROW GAP HEAT EXCHANGERS