Abstract:Unilateral surface compression in wood presents notable benefits, including reduced wood volume loss and energy consumption, rendering a highly promising and extensive utilization. However, shortcomings in compressed wood arise due to unclear gas pressure, temperature, and moisture content distribution within the wood during hot pressing. In this paper, the temperature and pressure distribution were analyzed utilizing an optical fiber temperature and pressure measurement system within the wood during hot pressing. Moreover, the moisture content, stress and strain in each layer at the end of hot pressing were discussed extensively. The results showed that the wood surface layer (SL) and subsurface layer (SSL) maximum temperature values were similar even with different layer thicknesses. Under sealing conditions, SL and SSL temperatures were generally 6 degrees C to 7 degrees C higher compared to unsealing conditions. The gas pressure maximum value exhibited an opposite order, gradually transferring to the core layer (CL) and declining as the processing time extended. During compression treatment, moisture migrated from the hot end to the cold within the wood. The moisture content displayed significant differences between the middle and end parts of the wood under unsealed conditions, with the disparity becoming more pronounced further away from the hot end. The transition region of the compressed wood served as a stress concentration area, experiencing the highest levels of stress. The dense region followed with the second highest stress levels, while the un-densified region exhibited the least amount of stress. Under the same process parameters, the thickness had little influence on the distribution of dense layers.

Transverse mechanical behavior of wood under high temperature and pressurized steam

Characterization of Tangential Shrinkage Stresses of Wood During Drying under Superheated Steam above 100 Degrees C

Tensile Stress Relaxation of Wood under High Temperature and Pressurized Steam

Characteristics of Shrinkage Stress of Wood During Drying under High Temperature and High Pressure Steam Conditions

Impact on Timber Crystallization Performance of Superheated Steam-Treated Wood under High Temperature and Pressure

Dimensional Stability Effect of Superheated Steam Drying-treated Wood under High Temperature

High-Pressure Treatment of Chinese Fir Wood: Effect on Density, Mechanical Properties, Humidity-Related Moisture Migration, and Dimensional Stability

Delayed Elastic Strain and Set-Recovery Evaluation in High-Pressure Densified Hybrid Poplar Wood – New Assessment Considerations

Tensile Properties of Finger-Jointed Lumber under High-Temperature and Oxygen-Free Conditions

Structural Characterization of Steam-Heat Treated Tectona Grandis Wood Analyzed by FT-IR and 2D-IR Correlation Spectroscopy

Behavior of Chinese Dahurian Larch Wood after High-Temperature Exposure: Degradation of Mechanical Properties and Damage Constitutive Model

Temperature and time dependence of orthotropic viscoelastic properties of moist wood determined in tensile mode

Dynamic Thermo-Mechanical Analysis for the Compressive Rectangle Wood

Change Rule of Internal Temperature and Steam Pressure During Wood Press Drying

Characterization of hygrothermal, gas pressure and stress characteristics for poplar wood during unilateral surface densification

Stress-strain Constitutive Relation of Longitudinal Compressed Fraxinus Mandshurica Rupr.with Hydrothermal-Microwave Treatment

Effects of Drying Temperature on Hygroscopicity and Mechanical Performance of Resin-Impregnated Wood

Effect of Drying Temperature and Relative Humidity on Contraction Stress in Wood

Effect of high-temperature saturated steam treatment on the physical, chemical, and mechanical properties of moso bamboo

The Effect of Shrinkage Anisotropy on Tangential Rheological Properties of Asian White Birch Disks

Measurements of the mechanical properties of larch at elevated and high temperature under nitrogen conditions