Properties of hydrogen permeation enamel barrier for stainless steel

Jie Tao,Zhendong Huang,Hongbing Liu,Jiang Xu
2008-01-01
Abstract:The purpose of this study was to investigate the preparation and efficiency of enamel barrier on the stainless steel against hydrogen permeation. Therefore, the preparation processes and the components of the silicate glassy coating were introduced in this paper. The nominal composition of SSE126 enamel frit was SiO2 35-45, B2O3 10-15, Al 2O3 2-5, BaO 2-5, R2O 15-20 and others 21.7(wt.%). The mixed raw mineral materials were melted at 1350□ holding for about 0.5h, and then the molten glass was quenched in water to get frit. The glass frit was milled for about 15h with some additives to attain the expected properties of resulting slurry. Then an enamel frit layer formed on the round angle substrates of SS316L, using dipping process following by spin-coating at room temperature. Thus, the vitreous enamel coating could form after vitrified for 3min at 770□ in air. The microstructure of the coated samples was characterized respectively by SEM, XRD, and EDAX. The experimental results indicated that the dense enamel coatings were chemically bonded with 316L stainless steel substrate, and possessed perfect thermal shock and ball-dropping impact properties. Hydrogen charging experiments were performed in a Sieverts apparatus. And the as-prepared compact density glassy coating with 90-100 micron thickness exhibited a perfect combination with the substrate and hydrogen permeation barrier effect.
What problem does this paper attempt to address?