Abstract:Piezoelectric wafer active sensors (PWAS) have been proven a valuable tool in structural health monitoring. Piezoelectric wafer active sensors are able to send and receive guided Lamb/Rayleigh waves that scan the structure and detect the presence of incipient cracks and structural damage. In-situ thin-film active sensor deposition can eliminate the bonding layer to improve the durability issue and reduce the acoustic impedance mismatch. Ferroelectric thin films have been shown to have piezoelectric properties that are close to those of single-crystal ferroelectrics but the fabrication of ferroelectric thin films on structural materials (steel, aluminum, titanium, etc.) has not been yet attempted. In this work, in-situ fabrication method of piezoelectric thin-film active sensors arrays was developed using the nano technology approach. Specification for the piezoelectric thin-film active sensors arrays was based on electro-mechanical-acoustical model. Ferroelectric BaTiO3 (BTO) thin films were successfully deposited on Ni tapes by pulsed laser deposition under the optimal synthesis conditions. Microstructural studies by X-ray diffractometer and transmission electron microscopy reveal that the as-grown BTO thin films have the nanopillar structures with an average size of approximately 80 nm in diameter and the good interface structures with no inter-diffusion or reaction. The dielectric and ferroelectric property measurements exhibit that the BTO films have a relatively large dielectric constant, a small dielectric loss, and an extremely large piezoelectric response with a symmetric hysteresis loop. The research objective is to develop the fabrication and optimum design of thin-film active sensor arrays for structural health monitoring applications. The short wavelengths of the micro phased arrays will permit the phased-array imaging of smaller parts and smaller damage than is currently not possible with existing technology.

Research on piezoelectric phased array for structural health monitoring

Piezoelectric Sensing Techniques in Structural Health Monitoring: A State-of-the-Art Review

Modelling And Simulation Of Phased Array Transducers Base On Advanced Ut Techniques

Ferroelectric Thin-Film Active Sensors for Structural Health Monitoring

RECONSTRUCTION OF PHASED ARRAY ULTRASONIC TESTING IMAGE OF THROUGH HOLE BASED ON FINITE ELEMENT ANALYSIS

A Study of Inner Crack Testing with the Laser Phased Array Method.

Continuous monitoring with a permanently installed high-resolution ultrasonic phased array

Design and simulation of a 2-D array flexible ultrasound transducer system for tissue characterization – A pilot study

Experimental and Numerical Investigation of Acoustic Emission Source Localization Using an Enhanced Guided Wave Phased Array Method

Composite Plate Phased Array Structural Health Monitoring Signal Reconstruction Based on Orthogonal Matching Pursuit Algorithm

Piezoelectric Transducer-Based Structural Health Monitoring

Piezoelectric Transducer-Based Structural Health Monitoring for Aircraft Applications

Development And Application Of Structural Health Monitoring System Based On Piezoelectric Sensors

Sector Piezoelectric Sensor Array Transmitter Beamforming MUSIC Algorithm Based Structure Damage Imaging Method

Simulation and Implication of a two-dimensional phased array flexible ultrasound system for tissue characterization

Phased array guided wave propagation in curved plates

A Lamb Waves Based Ultrasonic System for the Simultaneous Data Communication, Defect Inspection, and Power Transmission

Piezoelectric Materials and Sensors for Structural Health Monitoring: Fundamental Aspects, Current Status, and Future Perspectives

Recent Advances in Piezoelectric Wafer Active Sensors for Structural Health Monitoring Applications

A Review of the Piezoelectric Electromechanical Impedance Based Structural Health Monitoring Technique for Engineering Structures

Phased array ultrasonic detection using equal height focusing algorithm