Abstract:Piezoelectric wafer active sensors (PWAS) have been proven a valuable tool in structural health monitoring. Piezoelectric wafer active sensors are able to send and receive guided Lamb/Rayleigh waves that scan the structure and detect the presence of incipient cracks and structural damage. In-situ thin-film active sensor deposition can eliminate the bonding layer to improve the durability issue and reduce the acoustic impedance mismatch. Ferroelectric thin films have been shown to have piezoelectric properties that are close to those of single-crystal ferroelectrics but the fabrication of ferroelectric thin films on structural materials (steel, aluminum, titanium, etc.) has not been yet attempted. In this work, in-situ fabrication method of piezoelectric thin-film active sensors arrays was developed using the nano technology approach. Specification for the piezoelectric thin-film active sensors arrays was based on electro-mechanical-acoustical model. Ferroelectric BaTiO3 (BTO) thin films were successfully deposited on Ni tapes by pulsed laser deposition under the optimal synthesis conditions. Microstructural studies by X-ray diffractometer and transmission electron microscopy reveal that the as-grown BTO thin films have the nanopillar structures with an average size of approximately 80 nm in diameter and the good interface structures with no inter-diffusion or reaction. The dielectric and ferroelectric property measurements exhibit that the BTO films have a relatively large dielectric constant, a small dielectric loss, and an extremely large piezoelectric response with a symmetric hysteresis loop. The research objective is to develop the fabrication and optimum design of thin-film active sensor arrays for structural health monitoring applications. The short wavelengths of the micro phased arrays will permit the phased-array imaging of smaller parts and smaller damage than is currently not possible with existing technology.

Piezoelectric Transducer-Based Structural Health Monitoring

Piezoelectric Sensing Techniques in Structural Health Monitoring: A State-of-the-Art Review

Development and Progress in Piezotronics

Piezoelectric Materials and Sensors for Structural Health Monitoring: Fundamental Aspects, Current Status, and Future Perspectives

Ferroelectric Thin-Film Active Sensors for Structural Health Monitoring

Piezoelectric Transducer-Based Structural Health Monitoring for Aircraft Applications

Development And Application Of Structural Health Monitoring System Based On Piezoelectric Sensors

Self-sensing Joints for In-Situ Structural Health Monitoring of Composite Pipes: A Piezoresistive Behavior-Based Method

PZT Based Piezoelectric Sensor for Structural Monitoring

Piezoelectric Impedance Sensor-Based Structural Health Monitoring for Critical Members of Civil Infrastructures

Piezoelectric Transducers for Structural Health Monitoring of Joint Structures in Cylinders: A Wave-Based Design Approach

Recent Advances in Piezoelectric Wafer Active Sensors for Structural Health Monitoring Applications

Damage detection for structural health monitoring using ultra-sensitive flexible piezoelectret sensors

Radiation-Hardened and Flexible Pb(Zr 0.53 Ti 0.47 )O 3 Piezoelectric Sensor for Structural Health Monitoring

A Review of the Piezoelectric Electromechanical Impedance Based Structural Health Monitoring Technique for Engineering Structures

Ultra-High Sensitivity Anisotropic Piezoelectric Sensors for Structural Health Monitoring and Robotic Perception

A Circuit Design for Piezoelectric Impedance-based Health Monitoring

Identification of Static Loading Conditions Using Piezoelectric Sensor Arrays

Piezoelectric Wafer Active Sensor Transducers for Acoustic Emission Applications

Integrated Structural Health Assessment Using Piezoelectric Active Sensors

Wireless Structural Health Monitoring for Critical Members of Civil Infrastructures Using Piezoelectric Active Sensors