Abstract:The application requirements of high frame rate CMOS image sensors (CIS) in the industry have not been satisfied due to the speed limitations in traditional single-slope and serial two-step analog-to-digital converters (ADCs). In this paper, a high-speed fully differential two-step ADC design method for CIS was proposed. The proposed method was based on differential ramp and time-to-digital conversion (TDC) technology. A parallel conversion mode was formed that is different from serial conversion, and the robustness of the system was ensured due to the existence of differential ramps. Aiming at the inconsistency between traditional TDC technology and single-slope ADC, a TDC technology based on level coding was proposed. The proposed technology achieves the TDC in the last clock cycle of analog-to-digital conversion, and realized a two-step conversion process at another level. This paper presents a complete circuit design, layout design, and test verification of the proposed design method based on the 55 nm 1P4M CMOS experimental platform. Under the design environment of the analog voltage of 3.3 V, the digital voltage of 1.2 V, the clock frequency of 100 MHz, and a dynamic input range of 1.6 V, this design was a 12-bit ADC with a conversion time of 480 ns, column-level power consumption of 62 μW, differential nonlinearity (DNL) of +0.6/−0.6 LSB, and integral nonlinearity (INL) of +1.2/−1.4 LSB. Furthermore, it achieved a signal-to-noise distortion ratio (SNDR) of 70.08 dB. The proposed design provided a large area array with a high frame rate, and compared with the existing advanced single-slope ADC, its conversion speed increased by more than 52%. It provides an effective solution for the implementation of high frame frequency CIS.

A Column RSD Cyclic ADC for CMOS Image Sensor

A 14-Bit Column-Parallel Two-Step SA ADC with On-Chip Scaled Reference Voltages Self-Calibration for CMOS Image Sensor

A 14-Bit Column-Parallel Two-Step SA ADC with Digital Calibration Based on Scaled References and Redundancy for CMOS Image Sensors

14-Bit Column Readout Circuits with Single-to-differential PGA Using Intentional Offset and Two-Step Scaled-Reference SAR ADC for CMOS Image Sensors

A Novel RSD Correction for Pipeline ADC.

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

A 14-bit 150KS/s SAR ADC with PGA for CMOS Image Sensor

A 14-Bit 500-Ms/s Pipelined-SAR ADC in 28-Nm CMOS with Foreground and Background Calibration

A 14-bit 500MS/s and 1GS/s Configurable Pipelined ADC with Background Calibration

A 12-Bit Cyclic ADC for Image Sensor

A Low-Power Column-Parallel Gain-Adaptive Single-Slope ADC for CMOS Image Sensors

A 63.2μW 11-Bit Column Parallel Single-Slope ADC with Power Supply Noise Suppression for CMOS Image Sensors.

A Gain-Adaptive Single-Slope ADC Employing Column Lateral Capacitors for CMOS Image Sensors

A Single Slope ADC with Row-Wise Noise Reduction Technique for CMOS Image Sensor

A 12-bit compact column-parallel SAR ADC with dynamic power control technique for high-speed CMOS image sensors

Continuous-time ΣΔ ADC with implicit variable gain amplifier for CMOS image sensor

A low power 10‐bit 1 MS/s cyclic analog to digital converter for complementary metal oxide semiconductors image sensors with comparator‐based switched‐capacitor technique

A 2.72 μ s row conversion time 11‐bit column‐parallel single‐slope analog to digital converter with differential‐clocks‐assisted time to digital converter interpolation for complementary metal oxide semiconductors image sensor

An area‐effective and low‐power single‐slope ADC for DCG imaging CMOS image sensor

High-Speed Fully Differential Two-Step ADC Design Method for CMOS Image Sensor

A 1.8-V 14-bit inverter-based incremental ΣΔ ADC for CMOS image sensor.