Abstract:A full understanding of the material properties of skin tissue is crucial for exploring its tribo-mechanical behaviour. It has been widely accepted that the mechanical behaviour of skin tissue for both small and large deformations can be accurately described using a hyperelastic model, such as the one developed by Ogden. However, obtaining these Ogden parameters for in-vivo skin by in-vivo experiments no matter the indentation or suction tests is a significant challenge. The mathematical model used to describe the material behaviour during the test should consider not only the material nonlinearity but also the geometrical confinement of the tissue, the large deformations induced, and the fact that the specimens are relatively thin. A range of contact models is available to describe the contact behaviour during the indentation test. However, none of them can be used for hyperelastic materials with small thickness under large deformations. Simultaneously explaining material nonlinearity and geometric nonlinearity, either through theoretical equations or numerical calculations, poses a significant challenge. In this research, we propose a pragmatic method to obtain Ogden parameters for in-vivo skin tissue by combining experimental indentation results and numerical simulations. The indentation tests were used to obtain the force-indentation depth curves, while the numerical simulations were used to obtain the strain fields. The method assumes the material behaviour of specimens can be linearized in each small deformation increment, and the contact model developed by Hayes can be applied to accommodate each increment. Then, the linear elastic behaviour in each increment can be described by the elastic modulus E which were obtained using Hayes model, and the principal stresses in each increment were subsequently obtained using Hooke's law. By combining all stress fields, overall stress-strain curves can be constructed, from which the hyperelastic Ogden parameters can be obtained. A second numerical simulation of the hyperelastic indentation was then performed using the obtained Ogden parameters, allowing a comparison of the experimental and simulated relationships between force and indentation.

Identifying the Limitation of Oliver and Pharr Method in Characterizing the Viscoelastic-Plastic Materials with Respect to Indenter Geometry

Mechanical Characterization of Viscoelastic-Plastic Soft Matter Using Spherical Indentation

Macro-indentation testing of soft biological materials and assessment of hyper-elastic material models from inverse finite element analysis

Extracting the isotropic uniaxial stress-strain relationship of hyperelastic soft materials based on new nonlinear indentation strain and stress measure

Analysis of the Nanoindentation Data Measured with a Berkovich Indenter for Brittle Materials: Effect of the Residual Contact Stress

Mechanical characterization of soft viscoelastic gels via indentation and optimization-based inverse finite element analysis

Critical Review of Nanoindentation-Based Numerical Methods for Evaluating Elastoplastic Material Properties

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

Nonlinear Indentation of Second-order Hyperelastic Materials

Mechanical Properties Characterization of Two-Dimensional Materials Via Nanoindentation Experiments

The Influence of Indenter Tip Imperfection and Deformability on Analysing Instrumented Indentation Tests at Shallow Depths of Penetration on Stiff and Hard Materials

Indentation Method for Measuring the Viscoelastic Kernel Function of Nonlinear Viscoelastic Soft Materials

Determination of elastic moduli of polymeric materials using microhardness indentation

Determining the constitutive behavior of nonlinear visco-elastic-plastic PMMA thin films using nanoindentation and finite element simulation

Automated analysis of soft material microindentation.

A New Method for Determining the Ogden Parameters of Soft Materials using Indentation Experiments

Inverse Method to Determine Parameters for Time-Dependent and Cyclic Plastic Material Behavior from Instrumented Indentation Tests

Identification of plastic properties through spherical indentation

Berkovich indentation and the Oliver-Pharr method for shape memory alloys

Description of the Nanoindentation Unloading Curves with a Universal Function: Theoretical Consideration and Applications to Brittle Materials

Determining plastic properties of a material with residual stress by using conical indentation