Abstract:Segregation of the solidification structure of an immiscible alloy is related to the convection induced by the density differences of the components under gravity during solidification. Here, the solidification of the Al–Bi alloy in both opposing and parallel directions to the gravity force was investigated in situ using radiography and optical flow techniques. A quantitative analysis was performed on the flow, solute, and constitutional undercooling fields at the interface. During upward solidification, a flat solute-enriched layer was observed, with the melt flowing toward the center from both sides of the interface. During downward solidification, the solute-enriched layer was deformed, and solute plumes were observed, with the melt flowing toward the sides from the center of the interface. A high solute concentration gradient enhances the local flow and solute transport. The elongation of the plumes was attributed not only to the convective diffusion of the solute but also to the dispersion of droplet clusters. The forces acting on the droplets were calculated, and it was found that the resultant force on the droplets increased the area of the solute-enriched layer. Convection within the bulk melt and the motion of the droplets have synergistic effects on the flow pattern and solute distribution. Distinct microstructures were observed in opposite directions of solidification owing to the differences in constitutional undercooling and flow instability. This work offers insights into the quantitative measurement and understanding of the multi-physics fields during the solidification process.

Preparation of Homogeneous Al-Bi Immiscible Alloy by a Cooling Slope Method

Tailoring homogeneous immiscible alloy via magneto-Archimedes levitation

A Full View of the Segregation Evolution in Al–Bi Immiscible Alloy

In situ analysis of solute and flow fields in directional solidification of immiscible Al–Bi alloy

Preparation of Homogeneous Al-In Hyper-Monotectic Alloys with Copper Mould Rapid Solidification Method

Observation of Bi Coarsening and Dissolution Behaviors in Melting Al–Bi Immiscible Alloy

Study on Influence of Surface Coating During Cooling Slope Rheocasting Process

In Situsynchrotron Study of Liquid Phase Separation Process in Al-10 Wt.% Bi Immiscible Alloys by Radiography and Small Angle X-ray Scattering

Modeling and Simulation of the Microstructure Evolution During A Cooling of Immiscible Alloys in the Miscibility Gap

Phase separation and formation of core-type microstructure of Al–65.5 mass% Bi immiscible alloys

Imaging of Structure Evolution in Solidifying Al–Bi Immiscible Alloys by Synchrotron Radiography

The Core-Shell Structure of Al70bi11sn19 Immiscible Alloy Particles

Efficient fabrication of semisolid nondendritic Al alloy slurry with high quality

Core-shell structure with reversible composition of Al-Bi immiscible alloy particles prepared by pulsated orifice ejection method

Liquid Phase Separating Mechanism and Preparation Techniques of Immiscible Alloys

Preparation of Al-5.8%Cu Alloy Semi-Solid Slurry by Controlled Melting

Formation Mechanism of Microstructure of Melt Spun Al-In Immiscible Alloys

Controlling Droplet Distribution Using Thermoelectric Magnetic Forces During Bulk Solidification Processing of a Zn–6 Wt.%bi Immiscible Alloy

Effects of cooling rates on precipitates in homogenized Al–Cu–Li alloy

Dynamic behaviors of minor droplets and the role of bubbles in phase-separating Al Bi immiscible alloy

Segregation Driven by Collision and Coagulation of Minor Droplets in Al–Bi Immiscible Alloys under Aerodynamic Levitation Condition