Abstract:The traction converter modulation generates switching-frequencies current harmonics. The trapped filters can eliminate these switching harmonics, reducing total inductance and filter size. Nonetheless, in comparison with the typical inductor-capacitor-inductor ( LCL ) filter, the trap inductor needs a larger magnetic core. Moreover, the trapped filter has not been analyzed in the traction systems. This paper proposes a magnetic integrated inductor-trap-inductor ( LLCL ) filter to decrease the filter's size and investigate its application in traction converters. In fact, the application range of this filter is quite broad, and it can be used in various electrical power systems, including industrial power systems, renewable energy systems, transportation systems, and building power systems. The LC -trap may be formed by connecting the equivalent trap inductor, introduced through the magnetic coupling between inverter-side and grid-side inductors, in series with the filter capacitor. Furthermore, for H-bridge unipolar pulse width modulation (PWM) traction converters, the prominent switching harmonics are concentrated at the double switching frequencies. Therefore, the stability zone is expanded by moving the resonance above the Nyquist frequency. The presented filter's features and design are thoroughly analyzed. The proposed method is finally validated by the MATLAB/Simulink simulation and hardware-in-the-loop (HIL) experimental results. Compared to the discrete windings, the integrated ones can save two magnetic cores. Furthermore, the proposed filter can meet IEEE criteria with 0.3% for all the harmonics and total harmonic distortion (THD) of 2.15% of the grid‐side current.

Research of Adjustable Inverter Output Filter Based on DC Magnetic Flux Controllable Inductor

An Optimization Design of Output Filter in a Grid Connected Inverter With Flexible Multilayer Foil Technique

Study of Interleave DC/DC Converter in Energy Feedback Electronic Power Load

An improved control strategy for grid-connected voltage source inverters with a LCL filter

An Improved Control Strategy for Grid-Connected Voltage Source Inverters With an LCL Filter

Design of Input Filter for DC/DC Converter

Optimization of controller for single-phase grid-connected photovoltaic inverters

Optimized Design for the Inductor of Shunt Active Power Filter Based on Multi-Objective 4-D Visualization Algorithm

Inductor-Volume Comparison for 3Φ3W LCL Converter with Direct Digital Control and Different Filter-Inductance Drop-Rates

High-Density Planar Integrated Magnetics with Two-Sided Merged Inductor Windings and Integrated Cores for Resonant DC/DC Converter

High Efficiency Single-phase T-type LCL-filtered Inverter with Multimode Control and Smooth Mode Transition

Research on the Performance of Electronically Controlled Adjustable Inductor and Its Application

Adaptive Soft-Switching Control of Active-Clamping Three-Phase Inverters

Modeling and Design of Integrated Inductor and Transformer Considering Superposed Flux Density in On-Board-Charger

Accurate design, simulation and implementation of AC/DC inductors for power electronic converters

High-frequency harmonics suppression in high-speed railway through magnetic integrated LLCL filter

Research on output filter in hybrid active power filter

Low Frequency Current Ripple Suppression for Two-Stage Single-Phase Inverter Based on Impedance Editing

A DC Flux Cancellation Design Method for Inverse-Coupled Inductors Used in Interleaved Boost Converters

A Novel Varied Frequency Control Method Applied in Hybrid Electric Vehicle

An Enhanced-Boost Coupled-Inductor Impedance Network Inverter Without Limitation of Inductor Parameters