Abstract:Microscale boiling heat transfer experiments were performed using acetone as the working fluid in ten parallel silicon microchannels with hydraulic diameters of 155.4 mum. An infrared radiator image system is used for the chip temperature measurements, while an optical system combining a microscope and a high-speed camera is used for transient flow pattern identification. By covering the present data range it is found that all microchannels repeat the transient flow patterns in a timescale of milliseconds while the fluid pressures/temperatures are stable. A full cycle can be subdivided into three substages: liquid refilling stage, bubble nucleation, growth and coalescence stage, and transient annular flow stage. Correspondingly four flow patterns are identified. Paired or triplet bubbles are observed to be nucleated and grow up simultaneously in, or very close to, the channel corners at the same cross section. The nucleated bubbles experience several milliseconds of growth until coalescence takes place. Then a single liquid plug is separated into two parts, which are pushed out of the flow field view in less than 1 ms. In the transient annular flow stage, the liquid films that are drawn into the comers of the channel become less and less versus time. Once a partially or fully dried-out state is reached, all the microchannels are refilled with fresh liquid and a new cycle begins. The probabilities of each flow pattern occurring and the liquid refilling follow the statistical principle well. The measured chip temperatures are not uniform across the whole heating area, attributed to the uneven liquid refilling probabilities for different channels and the uneven possibilities that are immersed in the liquid for different heating regions. The chip temperatures display spatial variation behavior in the majority of the heating area, due to the liquid and vapor alternatively passing through the microchannels. To the authors' knowledge, some of the above experimental findings have not been previously reported.

Experimental Observation of Jet Flow and Liquid Exploding Emission from Mini/Micro Tubes During Boiling

Experimental observation of liquid exploding emission in micro tubes

Visual Study of Flow Pattern Evolution of Flow Boiling in A Microtube

Experimental Observation On Bubble Dynamics During Nucleate Boiling In Micro/Mini/Macro Tubes

Observation of nucleate boiling of water in mini-tubes

Jet Flow Phenomena During Nucleate Boiling

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

Jet Flows from Bubbles During Subcooled Pool Boiling on Micro Wires

Investigation of Flow Boiling Heat Transfer Characteristics of CO2in Horizontal Mini-Tube

Scale Effect On Boiling Inception And Bubble Dynamics In Micro/Mini/Macro Tubes

Jet Flows Around Microbubbles in Subcooled Boiling

Investigation of Bubble-Top Jet Flow During Subcooled Boiling on Wires

Experimental Investigation on Submerged Gas-Liquid Mixture Injection into Water Through A Micro-Channel

Flow Structures Around Micro-bubbles During Subcooled Nucleate Boiling

Bubble Dynamical Behavior and Flow Boiling Characteristics of Slug Flow in Hairpin Tubes

Experimental Study of Flow Boiling Regimes Occurring in a Microfluidic T-Junction

Visualization of Flow Boiling Experiments on Micro/Nanoscale Structured Surfaces in Microchannel

Flow Visualization and Local Measurement of Forced Convection Heat Transfer in a Microtube

Microscale Boiling Heat Transfer in A Micro-Timescale at High Heat Fluxes

EXPERIMENTAL OBSERVATIONS OF BUBBLE DYNAMICS ON ULTRATHIN WIRES

Experimental investigation on the characteristics of bubble growth and slide on a downward-facing heater surface in flow boiling