Surface Acoustic Wave DMMP Gas Sensor with a Porous Graphene/PVDF Molecularly Imprinted Sensing Membrane
Sheng Xu,Rui Zhang,Junpeng Cui,Tao Liu,Xiuli Sui,Meng Han,Fu Zheng,Xiaoguang Hu
DOI: https://doi.org/10.3390/mi12050552
IF: 3.4
2021-05-12
Micromachines
Abstract:In this paper, surface acoustic wave (SAW) sensors containing porous graphene/PVDF (polyvinylidene fluoride) molecularly imprinted sensitive membrane for DMMP gas detection were investigated. A 433 MHz ST-cut quartz SAW resonator was used to convert gas concentration changes into frequency shifts by the sensors. The porous graphene/PVDF film was fabricated on the sensor’s surface by using the tape-casting method. DMMP molecules were adsorbed on the porous structure sensing film prepared by the 2-step method to achieve the specific recognition effect. The sensitivity of the sensor could reach −1.407 kHz·ppm−1. The response time and recovery time of the SAW sensor with porous graphene/PVDF sensing membrane were about 4.5 s and 5.8 s at the concentration of 10 ppm, respectively. The sensor has good anti-interference ability to most gases in the air.
chemistry, analytical,nanoscience & nanotechnology,instruments & instrumentation,physics, applied