Optimizing nitrogen fertilizer application to improve nitrogen use efficiency and grain yield of rainfed spring maize under ridge-furrow plastic film mulching planting
Guangxin Zhang,Yan Zhang,Shiju Liu,Dehao Zhao,Xiaoxia Wen,Juan Han,Yuncheng Liao
DOI: https://doi.org/10.1016/j.still.2023.105680
IF: 7.366
2023-02-17
Soil and Tillage Research
Abstract:Efficient nitrogen (N) fertilizer management strategies are integral components of rational farmland cropping systems. Ridge-furrow plastic film mulching (RFPM) is a widely used micro-catchment planting system in the rain-fed farming area of the Loess Plateau in China, there are still problems of excessive N fertilizer application and unreasonable application method under this system. In this study, we conducted a two-year field experiment with traditional flat planting (FP) as a control, to determine the effect of N application rate (180 kg ha –1 , 240 kg ha –1 , and 300 kg ha –1 ) on soil nitrate N, total N, grain yield and N fertilizer partial factor productivity (NFPF) of spring maize under RFPM with three ridge–furrow ratios (RF40–70 = 40 cm:70 cm; RF55–55 = 55 cm:55 cm; RF70–40 = 70 cm:40 cm). In addition, under N application rate of 240 kg ha −1 , a micro-plot experiment was conducted to determine the fate of fertilizer N by applying N 15 -labeled urea on ridges and in furrows under RFPM, respectively. The results showed that compared with flat planting (FP), RFPM reduced the residue of NO 3 – -N (0–200 cm soil layer) and accumulation total N (0–100 cm soil layer) in the soil under three N application rates, especially under RF70–40. Reducing the N application rate decreased the accumulation of NO 3 – -N and total N under each ridge-furrow ratio. Compared with FP, RFPM increased the N accumulation, grain yield, NFPF for spring maize under all three N application rates. However, the N harvest index decreased as the N application rate increased under RFPM, thereby suggesting that the targeted N production could be improved for plants by optimizing the N application rate. By balancing the grain yield and NFPF, the optimal N application rates under FP, RF40–70, RF55–55, and RF70–40 were determined as 223 kg ha –1 , 204 kg ha –1 , 228 kg ha –1 , and 207 kg ha –1 , respectively, and these results also suggest that RFPM can lower the N input threshold compared with FP. In addition, N isotope tracing was used to clarify the fate of fertilizer N under RFPM, which showed that the contribution of fertilizer N to plants increased when N fertilizer was applied in furrows, and reduced the residual proportion of fertilizer N in soil. Therefore, our findings suggest that N fertilizer should be applied in the furrows after forming the ridges and furrows under RFPM.
soil science