Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Experiment Study of a Flexible Cantilever Beam with Time Delay in Control

Experimental study of wireless structural vibration control considering different time delays

Active Control on Coupled Bending-Torsion Vibration of Two-Link Space Flexible Component

Optimal Force-Balance Control of Closed-Loop Sensing Systems with Time Delay

DYNAMIC CONTROL OF TENSION STRUCTURES

Active Vibration Control of Flexible Structures with Super-Coiled Actuators

Active vibration control of a flexible beam based on experimental modal analysis

Active vibration optimal control of piezoelectric cantilever beam with uncertainties

Effects of Time Delay on Saturation Control of Flexible Cantilever Beam

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Analysis of Vibration Control of Nonlinear Beam Using a Time-Delayed PPF Controller

Dynamic Flexoelectric Actuation and Vibration Control of Beams

Stochastic Vibration Suppression Analysis of an Optimal Bounded Controlled Sandwich Beam with MR Visco-Elastomer Core

Adaptive modal vibration control for smart flexible beam with two piezoelectric actuators by multivariable self-tuning control

Static Nano-Control Of Cantilever Beams Using The Inverse Flexoelectric Effect

Experimental Research on Active Vibration Control of Flexible Cantilever Beam under Harmonic and Stochastic Excitation

Design and testing of a hybrid polymeric electrostrictive/piezoelectric beam with bang–bang control

Vibration suppression of a beam using variable structure control with disturbance observer

Simulation and Experiment of Active Vibration Control Based on Flexible Piezoelectric MFC Composed of PZT and PI Layer

Vibration Control of a Smart Beam Using H8 Control

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators