Research on biomass reburning denization characteristics

Pan Gao,LU Chun-mei,Lei Ruan,LIU Zhi-chao
2008-01-01
Abstract:A multi-purpose denitration test rig was utilized to study the reburning denitration characteristics of aspen wood sawdust, peanut shell, rice husk and cornstalk under the condition of typical influencing factors on reburning denitration. The test results show that when the furnace temperature is between 700-900°C, increasing the reburning temperature will result in a rapid increase of the precipitation speed of volatile matter in biomass followed by a quick enhancement of the denitration rate. At a temperature higher than 900°C, the precipitation of the volatile matter attains a saturation state and a relatively high furnace temperature tends to make the biomass to be heated, which leads to coke formation, enhancing the positive pressure of the furnace and causing the denitration rate to drop somewhat. The stoichiometric ratio (SR) has a relatively similar influencing effect for the reburning denitration of the materials under experiment. Four kinds of biomass all attain their highest denitration efficiency when SR=0.8. Under the same conditions, the smaller the biomass particle diameter, the greater the initial NO concentration and the better the reburning denitration effectiveness. A relatively big reburning fuel ratio (RFR) can compensate to a certain extent the difference in the denitration rate brought about by the reburning material particle diameter and initial NO concentration. To extend the residence duration t in the renurning zone is favorable to enhancing the denitration rate. However, when t > 0.81 second, its influence on the denitration rate will not be significant.
What problem does this paper attempt to address?