Abstract:Swirling flow induced by the twist vanes can enhance the heat transfer in the rod-bundle fuel assembly. In order to investigate accuracy of the k-epsilon models in predicting the swirling flow in a rod bundle subchannel, the CFD simulations with the standard and realizable k-epsilon model are benchmarked with In a al.'s experiment. The nonlinear closure models are utilized with the standard k-epsilon model to account for the curved and rotational flow, while the curvature correction model is employed in the realizable k-epsilon model. Comparison with the experiment indicates that the CFD simulations predict the relatively large core region of swirling flow. Utilization of the nonlinear closure models in the standard k-epsilon model leads to the larger initial angular momentum. The curvature correction in the realizable k-epsilon model reduces the initial angular momentum, but it does not affect the decay rate, which indicates that the curvature correction is effective near the twist vanes where the flow curvature is strong. The decay rate of swirling flow is generally overestimated by all the models. The cross-flow velocity profile in the gap is affected by prediction of swirling flow separation from rod surface. The cubic and quadratic closure model can improve turbulence modelling in the core of swirling flow, especially near the spacer, where the linear closure models significantly underestimate the production of turbulence. However, in the further downstream all the models underestimate the turbulence intensity in the swirling core, as a consequence of low-frequency large-scale flow structure in the core region. Underestimation of turbulence in the annular and wall region will result in the underestimation of wall heat transfer and inter-subchannel mixing.

CFD simulation of the flow pattern and separation performance in swirl tubes

CFD Analysis on Collection Performance of Swirl Tube with Different Vortex Finder Geometries

Numerical Simulation of Three Dimensional Gas-Particle Flow in a Spiral Cyclone

Numerical Simulation for Effects of Venturi Tube on Swirling Flow Field

Numerical simulation and analyze of three-dimensional strong swirl flow in the vortex tube

Numerical Study of the Gas Flow in the Swirl Tube

Numerical simulations of flow around two circular cylinders in cruciform arrangement and vortex structures analysis

CFD Simulation Study on Particle Arrangements at the Entrance to a Swirling Flow Field for Improving the Separation Efficiency of Cyclones

Numerical study on the performance of swirl tube based on orthogonal design

FLOWPATTERN EFFECT ON THE SEPARATION PERFORMANCE IN CENTRIFUGAL SEPARAT OR

Numerical Simulation of the Gas Flow in the Cyclone Separator Used in the CFB Boiler

NUMERICAL SIMULATION AND OPTIMIZATION OF GAS-SOLID TWO-PHASE FLOW IN ONE CFBC CYCLONE SEPARATOR

3D turbulent flow modeling in the separation column of a circumfluent cyclone

Numerical Simulation of the Swirl Flow Effect on the Cold Condition Characteristic of Entrained Flow Gasifier

CFD Simulation of Swirling Flow Induced by Twist Vanes in a Rod Bundle

Numerical simulation of energy separation effect inside vortex tube

Analysis of the three-dimensional swirling and non-swirling jet impingement using a turbulence model with cross-diffusion correction

Numerical Simulation of Flow Field in a Swirling Flow Tundish

CFD investigation of flow hydrodynamics and optimization in an industrial‐scale annular lance with swirl flow

Numerical Simulation of the Flow Field and Performance of an Innovative Cyclone Separator with a Downward Discharge of Gases

Effect of Swirl Flow on the Bubble Motion and Spatial Distribution in a Venturi Tube