Preparation and Characterization of One-Dimensional Nano-Structured Composite Cathodes for Solid Oxide Fuel Cells
Juan Li,Naiqing Zhang,Zhilong He,Kening Sun,Zhengbin Wu
DOI: https://doi.org/10.1016/j.jallcom.2015.12.166
IF: 6.2
2015-01-01
Journal of Alloys and Compounds
Abstract:La0.8Sr0.2MnO3/Zr0.92Y0.08O2 (LSM/YSZ) composite nanotubes of different diameters were co-synthesized by a pore-wetting technique as cathode materials for solid oxide fuel cells. A fast firing method was introduced to improve the contact between the LSM/YSZ composite cathode and the YSZ electrolyte, and to retain the original nanotube structure. The influence of heating and cooling rates, as well as the diameter of the nanotubes, on the microstructure and further on the electrochemical performance of the LSM/YSZ composite cathodes were studied. The microstructure study indicated that the LSM/YSZ composite cathodes, which underwent a 1100 degrees C heat treatment, exhibited nanotube and nanorod structures using heating and cooling rates of 200 and 100 degrees C min(-1). Area-specific resistance (ASR) of composite cathodes was characterized by electrochemical impedance spectroscopy. The nanotube-structured cathodes prepared using the heating and cooling rates of 200 degrees C min(-1) exhibited lower ASR than the nanorod-structured cathodes. For the nanotube structured LSM/YSZ composite cathodes of different diameters, the cathode prepared using the 400 nm template exhibited the lowest ASR. At 700 degrees C, 750 degrees C, and 800 degrees C, the ASRs were 0.55, 0.40, and 0.26 Omega cm(2), respectively. The low ASR was mainly due to the small grain size, homogeneous particle distribution, and fine pore structure of the material. (C) 2015 Elsevier B.V. All rights reserved.