Abstract:To accurately predict welding-induced residual stress and strain of high strength steel thick plate EH40 butt joint in single-pass full penetration laser welding, a complete solid phase transformation model according to the actual weld microstructure was proposed through material constitutive development. At the same time, the Case 1 considering the traditional thermo-elastoplastic were used as comparative study. The simulation calculation results and experimental results of each phase content were compared and verified. The stress and strain distribution of welded joints and the evolution mechanism of nodes in three zone including fusion zone, heat-affected zone and base metal were deeply studied and compared. The results indicated that the solid phase transformation had an obvious effect on the peak and distribution of longitudinal, transverse, normal and equivalent residual stress, as well as the stress gradient at the junction of heat-affected zone and BM. It increased the peak value of longitudinal residual compressive stress from –103 MPa to –768 MPa, with an increase of 645.6%. The stress gradient at the junction of heat-affected zone and base metal was up to 1299 MPa. The state distribution of longitudinal and transverse stress in the weld and its vicinity were completely opposite to the Case 1. The peak value of transverse plastic compressive strain increased from –0.059 to –0.111, with an increase of 88.1%. The fusion zone and heat-affected zone of the plastic strain in welded joints were more easily observed. It was found that martensitic transformation was the main reason for the obvious difference of stress and strain distribution and the evolution mechanism of stress and strain in the later stage of cooling stage.

Experimental extract of transformation plastic strain duringphase transformation

Experimental Research of Transformation Plasticity for Q460D Steel

A Multi-Phase Model for Transformation Plasticity Using Thermodynamics-Based Metallurgical Algorithm

Experimental study of martensitic transformation plasticity for armour steel

Characteristics of strain enhanced transformation and its influencing factors in Q235 plain carbon steel

Fundamental research of welding plastic strain evolution process: Characteristics and law of evolution process of welding plastic strain in mild steel, stainless steel and titanium alloy thin plate

DYNAMIC ASPECTS OF STRAIN ENHANCED TRANS-FORMATION IN Q235 PLAIN CARBON STEEL

Fundamental research of welded plastic strain evolution process II: Evolution process of welded plastic strain in thin stainless steel plate

Experimental Study of Transformation Plasticity During Martensitic Transformation in 5% Cr Steel for Backup Roller

STUDY TO THE EFFECT OF STRESS AND STRAIN ON MARTENSITE TRANSFORMATION KINETICS AND TRANSFORMATION PLASTICITY

Analysis of Martensitic Transformation Plasticity Under Various Loadings in a Low-Carbon Steel: An Elastoplastic Phase Field Study

Mechanisms of strength–plasticity enhancement and stress-induced phase transition in a medium-carbon low-alloy steel

Research on Modelling of Transformation Plasticity Via Dilatometric Tests

A micro-mechanical model of non-thermo-elastic martensitic transformation

Prediction and experimental verification of phase transformation plasticity

Micro-thermomechanical Constitutive Model of Transformation Induced Plasticity and Its Application on Armour Steel

Study of the effects of stress and strain on martensite transformation: Kinetics and transformation plasticity*

Micromechanics Model of Martensitic Transformation-Induced Plasticity

Ductility and strain-induced transformation in a high-strength transformation-induced plasticity-aided dual-phase steel

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Solid phase transformation effects on stress and strain in the thick plate EH40 welded butt joint