Abstract:It has been generally acknowledged that the configuration of a gas distributor has significant impact on fluid dynamics and mixing in shallow bubble column reactors.This study employs computational fluid dynamics (CFD)-based models to simulate transient gas-liquid flow in a large-scale shallow cylindrical bubble column of 800mm in diameter at the superficial gas velocity of 0.1m/s.An Eulerian-Eulerian two-fluid model along with the stand k-e turbulence model is adopted to simulate flow generated by gas sparged through five different multiple-pipe gas distributors which the four pipes are uniformly mounted at different distribution rings with ring to bubble column diameter ratios of 0.3,0.4,0.5,0.6 and 0.7.Multiple-Size-Group (MUSIG) model is also employed in the simulation to account for bubble break-up and coalescence.The effects of the diameter of distribution rings for allocating gas sparging pipes in the gas distributor on hydrodynamics,gas hold-up,mixing,turbulence and bubble size is systematically investigated.The simulation results clearly show that gas hold-up and mixing characteristics in the bubble column are affected by the ring to bubble column diameter ratio.It is demonstrated that the mixing time and overall gas hold-up increase with the increase of ring to bubble column diameter ratio initially but decrease with further increasing such ratio.It is found from the simulation that the optimum ring to bubble column diameter ratio is about 0.4 for the best gas hold-up distribution and such a ratio of 0.5 corresponds the longest mixing time.The CFD modelling results also reveal that the flow pattern inside the bubble column is dominated by single circulation when ring to bubble column diameter ratio is smaller than 0.5 while double-circulation flow appears when the ratio is larger than 0.5,thus impairing the mixing in the bubble column.A comparison has been presented between the simulation and the experimental data.

The Experimental Study on the Axial Solids Suspension Characteristics in Slurry Bubble Column

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Studies on hydrodynamics of slurry turbulent bubble column(Ⅰ) Gas holdup and its radial distribution

Experimental Investigation of Flow Development in Large-Scale Bubble Columns in the Churn-Turbulent Regime

Study on bubble size distribution and local gas holdup in bubble column

Studies on Hydrodynamics of Turbulent Slurry Bubble Column ( Ⅴ )modeling of Bubble Column with Multi-Layer Screens

Impact of gas distributor configuration on hydrodynamics in bubble column with pipe internals

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Bubble Size “bimodal” Distribution Enhances Mixing and Mass Transfer in Slurry Bubbling Column Reactor

Gas Holdup and Liquid Velocity Distribution in a Jet Loop Reactor

Distribution of Gas Holdup in a Slurry Bubble Column with Radiant Orifice Gas Distributor

Experimental Investigation on Solid Particle Distribution in Dense Solid–liquid Stirred Tank

Numerical Simulations Of Fluid Dynamics And Mixing In A Large Shallow Bubble Column: Effects Of The Sparging Pipe Allocations For Multiple-Pipe Gas Distributors

Application of CFD Simulation for Optimisation of the Multi-Pipe Gas Distributors in a Large-Scale Shallow Bubble Column

Experimental Measurement and Theoretical Analysis on Bubble Dynamic Behaviors in a Gas-Liquid Bubble Column

CFD simulation of effects of the configuration of gas distributors on gas–liquid flow and mixing in a bubble column

Experimental Study On Bubble Rising And Descending Velocity Distribution In A Slurry Bubble Column Reactor

Study of effect factor on solid concentrations in slurry bubble column

Rising and descending bubble size distributions in gas–liquid and gas–liquid–solid slurry bubble column reactor

Hydrodynamic performance and structural optimization of a slurry bubble column with vertical tube internals

Experimental Study on the Bubble Behavior in Gas-Liquid External Loop Reactors